Recent content by Schooler

Have you checked your timing lately? That can have a huge effect on your gas mileage if it's off.

I posted this in Classifieds but I thought I would do it here too. I need just the bellhousing for the 5 speed 2nd gen tranny shipped to 37604. Anyone have one?

I need just the bellhousing for the manual transmission on the 2nd gens, the R150h. Anybody have one? PM me with shipping to 37604

And how much did those cost you?

No this is BS. The guy that regularly does work on my truck says that only twice in his lifetime has he seen a tranny get worse after a fluid change. My a/t tranny is on it's last leg, really eaten up inside. I put seafoam cleaner in it (which will get all that goopy stuff out) and changed...

You guys considering the swap check this out: http://www.yotatech.com/showthread.php?t=71805&highlight=3.4+swap It will be more expensive than rebuilding or replacing your 3.0.

Check out this page: http://www.off-road.com/toyota/tech/other/4_axles.html It will help you determine exactly what gear ratio you have from the codes on your door.

I do not know about those types but I am looking for a good rack too. Can you post a link to them? What kind of ride do you have? My opinion on the installation, I was going to put into the factory rails because if you take them off, it might be hard to seal the roof up. Of course I have...

It is fairly simple to replace the CV joints. You can buy the whole reconditioned unit so you do not have to rebuild. I have a link somewhere for a write-up but I cannot find it right now--not on my computer. I will try to find it tomorrow for you.

I had to replace my tank as well on a 90. There is a small access panel under the rear seat on the passenger side which should give you just enough access to the cable clamp on the filler hose to get it off. Of course, I did not find this panel until I got the tank off by disconnecting the...

No way--that is high. If you didn't get any "real deals" you could get the same vehicle in that condition without a new engine for $3000. Then you could rebuild the engine for $1500 and have the same thing for $4500. Make sure you check the 4x4 and look at all of the IFS components. Look for...

Ooo yes...Check this out: http://www.auto-interior.com/moldedvinyl.htm I have been thinking about this but cannot find anyone else who has it. I think it would definately increase the sound inside. The slots behind the seats would still be there but you could just wipe it down instead of...

Yep, 8 hours to go and $77

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=8012774930 Looks nice, and only $21 right now

Yes Tellico is at least a 4 hour drive from me and in NC. I am looking for a local place. Uwharries is also about 4 hours and in NC.