Recent content by Shmuckatelly

  1. S

    The 3rd Gen All Questions Allowed Thread

    Steering rack alignment Hello, I recently installed a new steering rack while installing a long travel kit. I do not believe the rack is alligned properly between the threads from the inner to outer tie rod, how should I go about fixing this? Thank you!
  2. S

    The 3rd Gen All Questions Allowed Thread

    I forgot that piece, put that on and everything lined up, thank you!
  3. S

    The 3rd Gen All Questions Allowed Thread

    I am in fact running the Tundra axles. I will get a photo when I can, but the situation I am in is the one you described second where the axle is sticking out past the nut altogether.
  4. S

    The 3rd Gen All Questions Allowed Thread

    Long travel kit install question Hello, I installed a Solo Motorsports long travel kit, currently my CV axles are sticking too far through my stock spindles to where the cotter pin hole does not allign with the axle nut slots. Any reason why this might be? Thank you!
  5. S

    The 3rd Gen All Questions Allowed Thread

    Hi sorry for not responding all, but I have a 2000 Toyota 4runner limited with the center locking diff. I have about 225K miles on it and I just wanted something along the lines of beefier and a slower speed. As in the car moves slower in 4 low. I also am installing in the near future a Solo...
  6. S

    The 3rd Gen All Questions Allowed Thread

    Transfer case What are my options for upgrading a transfer case in the 3rd gens? Thanks all, I don't even know where to start looking at this stuff haha.
  7. S

    The 3rd Gen All Questions Allowed Thread

    Locked diff, manual hubs Hi, I just had a question regarding the combination of manual hubs with a locked differential. Solo Motorsports has an adaption in there long travel kit to have dana 44 manual locking hubs. I figured I could do those and then get a spool piece for the front instead of a...
  8. S

    locking differentials

    Locking differential, Manual hubs Hi, I just had a question regarding the combination of manual hubs with a locking differential. Solo Motorsports has an adaption in there long travel kit to have dana 44 manual locking hubs. I figured I could do those and then get a spool piece for the front...
  9. S

    3rd Gen Build Thread Directory

    Lift Kit, thoughts? Hello all, I'm new to this site, but I can here looking for advice/suggestions. I am planning on doing a lift and I've been putting together this list for a while. Tell me what you think! • SPC UCA (SRQ Fab) • Opt Off Road LBJ rebuild RLCAs • Lower Ball Joints • • Driver -...

Members online

Forum statistics

Threads
278,310
Messages
3,554,080
Members
248,016
Latest member
Advally Service
Back
Top