Recent content by Stuntmonkey

So my back left flare, the top part got ripped off by a flying object on the highway, I need to replace it. Is it possible to buy new ones from somewhere? I'm not having a lot of luck..

Just drove home, DRLs unplugged. Highbeams worked. I also didn't realize that the handbrake indicator light or seatbelt lights weren't coming on. And now everything is working. Has to be a dirty common ground.

1997. Disabled by unplugging module behind drivers side headlight. I've done it before and high beams worked fine. I only unplugged it just before my last post. Plugged it in again and symptoms are the same.

100% positive the highbeams aren't working after the DRLs were unplugged. I've got to head off to work (14, 10hour days, REALLY suck), so I'll update this tomorrow when I get up and trace this back from the bulb. Thanks again.

Just to add to the confusion, I disconnected the DRL because it was annoying me. When I pull the stalk back to flash high beams with lights off, the lows come on. And I believe I must have a different pin out than those ones you provided, looking at my stalk connector, I have nothing in pin #...

If I jumper 1 and 2 on the fuse block, with my highbeams on at the stalk, they come on. This is why I originally thought it was the fuse. Dimmer is the one I've been playing with, I was just curious to the HEAD down the bottom right.

Yup terminal 2 is getting 9v while on and then 0v when off. Tested this with lights on and off on the stalk, and then flashing high beams while lights were off. What does the HEAD fuse control? Is that just the overall power to the headlights?

Jumped 16/7 and the low beams came on with the high beam indicator light. So whatever part of the high beam circuit that puts them on isn't coming on for some reason. Both filaments light up for high beams. UGH, this is a massive headache. I drive back home through the country roads and high...

I have DRLs, but did not know that about the light. Makes sense though. Which is why it comes on. I'll try and source a stalk if its not expensive. I've been trying to find the pin out so that I can jumper the plug at the stalk to see if they come on, but haven't had any luck.

So picked up a new dimmer relay, freaking $85. No high beams still!! I understand its a switched ground, but in the indicator light is coming on, I can't figure out what the issue is? High beams work AT the fuse when jumpered, so I guess I need to work my way back to the stalk?

Jumpered the prongs in the fuse that had resistance, low beams come on. Jumpered other 2, and voila! High beams. New fuse I guess.

Hola! So my high beams aren't coming on. Indicator light is, low beams and DRL work. Fuses are fine, bulbs are fine, both filaments are fine. I'm being lead to the dimmer relay? It doesn't click when I switch it to high and low. I don't have a schematic for it so haven't got a clue which 4...

Just did mine at 115k miles, was in decent condition but I wouldn't really push it much further. When it goes, you're screwed.

I think that is the one. I need the 2 end sections of the 3 piece chrome bumper. 9 & 10 in this pic. I believe you need #1?

Made some 3/8" MDF mounts for my 5 1/4" speakers in rear doors.