Recent content by suppra87

  1. suppra87

    Cold start fires right up, let it sit for an hour and it will just crank

    Supermoney Mechanic here, Ive experienced this a few times on LC80's. Check/replace the 2-pin coolant temp sensor for the computer. I think its front and center of the lower intake manifold on the 5vz. When they go bad they typically tell the engine to run pig rich on a warm/hot start which...
  2. suppra87

    Is anyone running "TRD 17-In. Matte Black Alloy Wheel - Trd Pro" on their 3rd Gen ?

    I run them on my '98, I used 1.25" spacers for a better look but they actually fit better without spacers. They stick out 4mm more then a stock 16" twinspoke, cant speak for other factory wheels though. My truck Edit: And they do fit over the 231 tundra brakes with or without spacers.
  3. suppra87

    How often do you clean your MAF?

    I change my air filter with a Denso every 10k and have cleaned my MAF once in my almost 2 years and 25k of ownership. Clean it when I got the truck because I figured, why not? Sitting at 248K currently. Maybe its time for a new MAF?
  4. suppra87

    Radiator hose flat?!

    Certainly a bad Radiator Cap. Odd that its a new OEM cap defects to happen.
  5. suppra87

    Can't decide what wheels to buy!

    I prefer the Raceline but my second choice would be MB 11.
  6. suppra87

    Stalls while stopped in D

    I had a very similar issue come about on a customers Nissan Xtera. It would only stall in drive or reverse. Park or neutral were normal engine idle, no vacuum leaks or engine codes. The torque converter clutch was stuck locked up in this case, thus causing the engine to stall. I replaced the...
  7. suppra87

    Upper fuel line

    Yep, you can rent a tubing flare kit and buy a small section of 5/16" hardline and a inverted flare union. Cut the line a little further up with a pipe cutter and splice in your repair section. I changed the fuel filter on RPS99SHO rig and the line started to leak from the corossion with in...
  8. suppra87

    Tundra Brake Update: What Brands Did You Use?

    I went with OEM calipers and hardware, Hawk HPS pads and Stoptech cryo treated slotted rotors. Also Toytech braided hoses. Ive got 10k miles on them so far and love the combo. Stops extremely well with very little dust, no noise and have yet to get them to fade.
  9. suppra87

    How much did you pay for your 3rd gen?

    $1500 for my 98 Limited one owner with 231k. Bone stock, all records, crystal clean everywhere, zero rust.
  10. suppra87

    3rd gen died today

    Another vote for the Alternator. Be sure to charge up the battery before you install it though, not good to put a high charging load on a fresh alternator.
  11. suppra87

    Lower Control Arm Failure???

    That is pretty wild. Ive only seen a LCA fail like that from being in an accident. Otherwise its always the lower ball joint.
  12. suppra87

    Why Such Varied MPGs w/ 3.4 V6?

    You all are making me feel pretty decent about my gas millage haha. Ive been consistently getting 15mpg mixed city/highway and 16-17mpg all highway driving @ 75-80mph. Closer to 16mph when I'm driving into the mountains. Keep in mind, mountains in my area max out around 2200ft. My truck has...
  13. suppra87

    New (to me) Runner

    Amazing find!! All original, leather, dealer serviced and my favorite color, I'm jealous man.
  14. suppra87

    Towing a 4Runner, with a 4Runner?

    I think you will be fine towing a 4Runner with your 4Runner. You may end up slightly over the 5000 lbs towing capacity of your runner, which is obviously not advisable, but if you mind your braking distances and your speed you will likely be alright. I have a similarly equipped 4runner (240k...

Members online

Forum statistics

Threads
278,309
Messages
3,554,071
Members
248,016
Latest member
Advally Service
Back
Top