Recent content by swimbikerun247

Unfortunately, I sold this one back in August to pay off my wife's student loans. However, I'm back in the market looking for a good 1st gen project.

I'm looking to buy the shifter bezel or trim that goes around the manual shifters in a first gen 4Runner. Needs to be grey. Thanks.

I'm looking at doing a rebuild in my 1986 4Runner. Instead of pulling the 22RE out of the 86 and rebuilding it, I'm considering pulling a 22R out of an 83 Toyota Motorhome. I've read that the motorhome motors produced quite a few more HP but I'm a little confused, is this correct? Can anyone...

Looks like the 60" Extreme shouldn't have a problem making, so might as well switch me over to it with a NJC as opposed to the 48" red. Thanks.

Put me down for a red one with a NJC. May be interested in the 60" if it comes through.

I'm reinstalling my rear seats in my 87 runner. The bases are already installed but I'm not exactly sure how the backs were attached to the center brackets at the bottom that fit between the 50/50 split seats. Can anyone provide pics or advice as to what hardware or equipment is used to...

Agreed on all accounts. I have a set in my DD Tacoma but would like to find something cheaper for the rear seats in the 4runner.

I'm looking for the same thing. If I can't find any I'm putting in a set of 2nd gen seats but would rather not have to drill new holes.

Sorry, it's long gone bud.

I'm looking to buy 4 or 5 33x10.5x15s. I'm in south Alabama but travel a decent bit as well.

I already have a Yakima LoadWarrior roof rack. I'd like to buy an extension for it if anyone has one. Thanks.

Several 4runner projects underway at the moment. I've completely replaced almost everything as far as the front driver's side suspension and steering goes. Now I've tore apart the passenger side (includes shocks, cv's, upper and lower ball joints, inner and outer tie rod ends, adjusting...

I want a set.

Updated pics of my rear suspension. Still have to clean and paint a few things (mounts, shackle hangers, u-bolt plates, etc). Also cut off the stock rear hangers after taking the pics.

I think my CV boots are in pretty rough shape. Replacing CVs, tie rods, ball joints, shocks, sway bar links, and idler arm. Adding BJ spacers.