Recent content by symlink

Clean, but that guy is smoking something. Ill tell you what. Ill sell mine for half with lower miles lol. 17k....

Any know the hose size of the hose that is closest to the throttlebody that connects to the intake? I tried 3/8 but it was too small so im assuming its 1/2".

Personally here what I would do because it sounds like its in need of some maintenance. Get a can of Seafoam and seafoam it (youtube videos will help if you don't know how) Replace plug wires/make sure you have the right spark plugs Replace the Fuel filter Buy a can of the CRC MAF cleaner and...

Yes sir, they are not large enough to move small rocks but will get dirt and pine needles etc out without the worry of blowing the tubes out. I also take a little bit of silicone and spray it on a rag and wipe the edge of the gasket for the sunroof helps keep it from drying out.

I've always just took a small can of air and stuck the nozzle in the drain hole its worked out pretty good. I think the main concern is using a huge compressor and blowing tons of air through it.

Is pulling one off a junker out of the question? Probably no more than 50 bucks for the glass and everything. I'm sure even if you had one shipped it'd be under 100 bucks. I paid 125 for a mint one for my 1st gen from a member here.

This is exactly what I ended up doing however with a slight variation. I had new endlinks with their supplied bushings that went on without and issues. So I put the bushings on one side and then took the prothane bushings and put them on the other side. After they went on I went back to the...

Yeah they are both loose :/ one endlink was actually completely gone towards the top

Not lifted, yeah the front ones and the end links are from importdirect (oreillys) the bushings are prothane. The problem is getting them squished enough to get the nut started. Ill five the channellocks a try first thing in the morning along with the others mentioned. Thanks!

Longtime lurker here needing a bit of help with my first time changing endlinks out. I bought the prothane kit off amazon and swapped and painted my swaybar and swapped the bushings at the same time. The issue I have is for the life of me I can't get the nut on the bushings for the new...

Wow, Nice not everyday you see a diesel. Best of luck with sale, I'd scoop it up if I hadn't just had a kid. If you end up going the route of parting it out let me know as I'd like to have the first crack at the bumper/possibly purchasing the motor. I'm also rather local about a 2.5 hr drive for me.

Thanks, Got them price-matched at my local goodyear store for the duratracs 4 for 600 bucks can't beat that.

Just wanted to pop in here called and got the same deal no questions asked they said they could do 154 a tire.

Try with the MAF. then I'd probably replace your A/F Sensor as mine was doing the exact same. It wasn't until I replaced it that it fixed the issue.

Was it paid for? or is that after paying off all the loan etc? because in the south here you couldn't even think of getting a 4runner for that price. If they said that to me I'd raise all kinds of hell.