I was going to experiment with mine eventually despite not-so-encouraging information in TIS and from other members.
The onboard electronics pretty much run the show with regards to the RAS pump... Not sure if control can be overridden or if the pump can cope with high pressure.
weird, my Canadian truck had RAS from the factory and it has a tiny little spring perch on the axle. I got the top isolators with my FJ springs and installed them carefully, just feeling and looking around to make sure everything seated right. In the end it looks and feels like the springs were...
I measured my FJ rears when I put them on and they were not the same length. One was a few tenths longer than the other. Just FYI.
Both were ~1" longer than the spring they replaced too, which were also not the same length side to side.
Tacos up front will give a little more length than FJ...
Nice. How do the dual camera ones display video? Is it like a split screen file?
I've always been curious about that.
I would probably consider hardwiring mine when I get one just due to the fact that I always have a million things plugged in.
I'm in the market for a new dashboard camera, trying to figure out which way to go.
Thinking of ordering a bunch of cheap China cameras to test them out.
I've also heard there's a new Canadian company that's putting out a couple cameras with a 3yr warranty but haven't found them yet.
Any recos?
I would do it for free if you were local!
I actually don't know how accurate the TS is vs the SG but I am inclined to trust it. I ran my TS in real time while driving and watched it fluctuate and do it's thing. Seemed to meet my expectations anyway.
Hooked it up in stop-and-go traffic after...
Debating upgrading to LEDs (Xenondepot most likely) but not sure if these will look douche-y or cause glare and get me high-beamed like some HID upgrades.
Was hoping the lower output than Xenons would mitigate this, but was wondering if anyone here did the swap.
Thanks!
I was at Princess Auto today and I wondered the exact same thing.
I will say, using Techstream with a $30 cable reads out accurate A/T temp data, so that has been my go-to lately.