Recent content by Tack427

Thank you. I had an idea last night that might work. I could cut a old shifter and weld a peice to it so it will move under the floor and then come out behind the b&m shifter. Dog leg it.

Ok heres a quick run down on the truck. I bought someone else's project. I know alot about american cars but not much about toyota's. Heres what it has. Chevy350 motor/trans Toyota TC Toyota front and rear axle's 3 inch body and 3 inch suspension lift 35x12.50 on 15inch wheels b&m ratchet...

After you get the whole window out there are some screws that you remove to get the L shaped trim off.

1)Get inside the truck first. 2)Then I think there is some rubber weatherstripping around the window that you can pull off. 3)Pull it off. 4)Get a razor knife. 5)Cut the glue that is between the fiberglass and the metal frame. Once you get most of the glue off you can push the window or...

i have a chevy350 in my 84 4runner with AA gear

yes and no. The truck was allready built up which saved me tons of work and money. I bought the truck for $600. I thought the motor or head was cracked. But it turned out to be just the head gaskets and freeze plug. So I fixed those problems dropped the motor back in. But I still have...

Thanks, Its just about finished. I had to replace the head gaskets on the 350. New air cleaner and valve covers too Just need to add a new alt. and fresh battery and the wire the cab (radio, dome light, light bar...etc.)

84 4runner Chevy350 motor 35inch Mudders Almost done. What do you think?

Thank you

Does anyone know if a 87 dash pad will fit a 84 4runner. I have a chance at getting one but not sure if it will fit.

anyone else here anyone?

Hi I'm from Boston MA. I just picked up a 84 4-runner with 4 inch lift, 35x12.5 Mud Kings 15" rims, Chevy 350/TH350 Swap. Only thing really wrong with the truck is the motor is blown. (Cracked Block or Head) But I'm buildin a new 5.7 in my garage right now. Just a low end torque motor.