Recent content by TexasSlinger

Did smoke test on mine and found smoke coming out the top of filler tube. Ordered gas cap. If not that then the filler neck Sent from my iPhone using Tapatalk

Man I'd start looking into the main drive shaft. If it were mine id disconnect the front drive shaft and take it for a spin just to rule it out. Suppose the u joints are good on the main drive shaft Sent from my iPhone using Tapatalk

Yea that's what I figured. The big one on pass side is squished out. Likely original Sent from my iPhone using Tapatalk

Hey gang Just bought an Non Limited 02 4x4 v6 auto with 197k on it. Real nice rig 1st problem. I feel a slight looseness in the steering wheel like there is a little amount of play especially when going over small bumps. Do the lower shafts wear out on these? 2nd problem the air mix motor...

What plugs you put in. I inadvertently installed champion and it ran like ass. Put oe type in and cleared up. Also swap plugs from one side to the other and re scan for codes. I had wires melted to plugs once too Sent from my iPhone using Tapatalk

When you say front end, mean steering wheel, seat, chassis? And everything new and tight like control arms, ps rack, driveshafts. I replaced the rack and drive shaft on the Tacoma and it's pretty smooth. You get shimmy when braking? Sent from my iPhone using Tapatalk

Yea, it's a bummer bout the passes. Going back in summer too likely. Went 2 februarys ago and i70 was a pain. Storm came out of no where. Had a rental Dodge Dart and barely made it. Should be more suited this time around. Glenwood Springs and Copper Mountain here we come! Sent from my iPhone...

SE Texas is full of private property. Fortunately there are public beaches. Sargent, and Matagorda. Galveston too but pretty populated. Day trips are excellent. Must haves are chairs, beer, drinking water, rinse off water, shovel, pop up tent (yet to be used). Snacks and an ice chest. My 3rd gen...

I was under mine doing a xfer case fluid srv and was wondering how a diff drop would work cuz there was little wiggle room between cross member and diff Sent from my iPhone using Tapatalk

Nice. Bout a bill or 2 saved Sent from my iPhone using Tapatalk

Cool! Anyone want em?? Just pay shipping. $15 PayPal Sent from my iPhone using Tapatalk

I replaced the starter on the Tacoma. Little did I know there was a cheap rebuild kit. I can try to find it... Sent from my iPhone using Tapatalk

Anyone know what these are? Prol don't need them... cross bars keeping Sent from my iPhone using Tapatalk

I'm coming from a 00 Tacoma. I'm actually trying to get my post count up. Been looking at runners all my life. Had a 00 4wd Tacoma in 2003 ish. Been looking at runners the last 6 months again. I didn't want a note so got a 02 sr5 4wd with leather and sunroof. Gonna sell the taco to offset price...

I replaced my ps rack on the 00 Tacoma. Came with new clamp bushing which had failed as well l. whole unit was leaking bad. Old bolt bushings I drove out of old and put in new rack. Drove like a dream after alignment. Came fully assembled. Inner and outer ties rods. ASAP in Houston Rosenberg...