Recent content by TheHoneyBadger

I have my sway bars connected and haven't really FULLY flexed out the rig, but under flex is when it's heard. Driving on flat pavement and soft bumps they're quiet. I suspected that the moog replacements may be to blame. Is there a noticeable difference in the diameter of the top of the coil and...

Has anyone else had problems with the rear fj coils making noise? I've been running mine for 6 months now, and it hasn't gone away. I've double checked that they're seated properly and everything. No other issues fronts are quiet, rears just make a "boing" noise on bumps. I will note that mine...

His body lift is mostly to clear the turbo hardware and still keep it higher than the frame ,so he doesn't rip it off. Though I'm sure it does help, with tires. i plan on ordering a 2" kit from phat pat. I plan on coppying his turbo at some point also. I cleared my 33's with zero lift and...

Brimbo pads, new rotors, stop tech stainless lines, and paint for my 231 calipers [ATTACH] Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

Finally replaced the cheapo auto zone pads i got when i did the 231 upgrade... won't be doing that again, dust everywhere, they[ATTACH]squeaked, and they never​ seemed to grab quite right. However, i will note that if you tell Auto zone that your rotors are warped, they'll replace them, no...

PM sent. Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

Check your u joints while you're under there. Mine did the same thing before i replaced my joints last week. Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

This is a bada$$ build that is always fun to check up on. Lots of inspiring fabrication. Will be glad to see you get back to it! Nice fj though. Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

Also running this setup, with good success. Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

Couple shots of the reverse lights. Output is pretty outstanding. Also a shot of how i ran the wiring. Power goes through the hinges and tucks behind the weather stripping, then follows the frame to the relay by the battery. Mounting bolt for the hatch hinge is where i grounded. Pretty pleased...

I got some LED reverse lights, a curved 42" light bar, and a panel that has LED rocker switches and marine grade 12v outlets from my girlfriend's parents for Christmas. I've had the switches and reverse lights installed for a while, but forgot to post a pic. Did the outlets today. Switches and...

I used the non ABs master Not sure on part numbers. I'll definitely be going with stainless flex lines for the front. I need to do pads and turn the rotors soon, so I'll be doing it then. Never enough time in one weekend to do everything my truck needs lol. Build thread...

Thanks. No, i grabbed some re mans from Autozone. Not ideal, but i have to drive a long ways to find yards with Toyota's in them. Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

Upgraded to 97 t100 1ton brake booster and master cylinder. To help with tundra 231s. Way better brake pedal now. Write up in my build thread if anyone is interested. [ATTACH] Build thread: http://www.toyota-4runner.org/showthread.php?t=219718

Thanks man, I've seen your rig and will take that as high praise. 4wd swap is happening soon hopefully. I've been waiting on moving to my new place, but that's only a week away now. So, hopefully after that i can get cracking. Build thread: http://www.toyota-4runner.org/showthread.php?t=219718