Recent content by Theslammer21

(4) 2011 SR5 17 inch wheels with tires (no sensors). lifted it at 8000 miles. don't need these anymore. 9/32 of tread. LOCAL only las vegas asking 600 email for pics. [email protected]

thinking about doing a write up. no safety issues. this will only change the actual engagement height, once the brakes are engaging, they will have the same feeling it did before. the stock pedal height may portray a feeling that the brakes have air because of the travel

Too much travel until brake pedal engages. Adjusted push rod with volt meter on master cylinder pressure sensor. Adjusted all the way until I saw a change in pressure and turn back one full turn. Also hear that squishy sound from air escaping from the dust boot to the actuator/ master cylinder a...

I'm at 0.0 camber 1.3 caster and .02 in on the toe to help the wonder.

heres the bulletin

NOTICE: Perform Reset Memory (AT initialization) when replacing the automatic transmission assembly, valve body assembly or any of the shift solenoid valves. Reset Memory can only be performed with the Techstream. pulling the negative isnt fully dumping all the learned values that was...

im just going to throw this out there from the repair manual that may be some proof that the ecm does adapt to driving depending how you take it. from personal experience, driving multiple customer vehicles a day, every single one drives differently and i can usually confirm it by looking at the...

the cut off has nothing to do with the amount of compaints. that when they actually changed the seatback assembly at the factory. the updated part in the bulletin is already in vehicle after that vin range

heres the bulletin

i have seen the immobiliser set before if the car was left unlocked or a door open for a while and the battery voltage dropped slightly. in that case you need to close the hood and close the door. lock the vehicle with the smart key and then unlock it after and attempt to start it. i know you...

do you have any pics of how the awning is in the closed position?

im sure you could unplug the yellow connector under the seat in which would not see the occupant classification sensor.

you may not have to disconnect both connectors on the side of airbag but the main connector that they both lead to. this will require glovebox removal

heres a small pic for you

just unplug it. you will have an air bag light on your dash. its a small red light which isnt annoying to see during night driving as would a yellow one (ex check engine light. it will set a trouble code for open circuit on passenger airbag in the airbag ecu but will not cause harm to the system...