Recent content by TOY2G

The solution I may have figured this out. I bought a couple 200 series and they did the same thing, then the wife got a 2021 GX460....same thing. I don't want to be suspenseful so Ill get to the point and back track. The heat shield matting above the muffler can overheat and in fact burn...

Mine was in regards to the 4th gen, I don't know if any of it translates to the 5th gen.

This is a pretty old thread and we did the conversion with a writeup a couple years ago. there should be plenty of interest in these gauges if youare trying to sell them.

Well, that was a fail. I dont have any that are not cut in half.

Just shipping.... I will go see if i can dig up a set after lunch

I have a set or two sitting around from bumper installs. do you just need the black ring?

How much for just the lights?

I've taken my 2008 Tacoma with 231k to Texas and back to Ohio recently, I also, on more apples to apples note... I drove my 277K Mile tundra (4.7) to and from Texas many times as well as my 207k mile 2003 GX470 from Ohio to Colorado and then also to Texas and back (pulling a trailer). The odds...

I Did It I had to add this to mine, but the only way was to buy the entire overhead console. It is plug and play, but finding one is expensive and hard to locate.

That's the center diff lock light, (or rather half of it). Likely a burnt LED, probably part of the board.

We picked up a GX470 for my son and a GX460 for myself as our 2019 Builds. We got right to work. We did typical maintenance like water pumps, timing belt (GX470), tranny flush, power steering flush, exc. Turns out I had a bad coolant leak that took a lot more work than I had planned for...

This wont fix anything. if they are not using the lugcentric adapter to balance the tires and wheels, they are never going to balance on the truck. Our wheels are large hub wheels and look hubcentric. but you can tell from the lug nuts it is lugcentric. you need lugcentric wheel with...

Ill be in Norwich over thanksgiving, I might be interested in the compressor setup if you still have it.

you can get them off ebay for a fair price and then do the work yourself. all of mine now have inlays in them (because i got all fancy pants).