Thanks much for the replies.
Think those 9mm wide clamps from ebay will just barely fit the boot channel on the 1st gen Tundra but it seems 9mm is a little wide, although the rolled edges might help. OEM clamps are 7mm I think. Can put a couple ¼” wide ⅝” $.99 hose clamps from the hardware...
Thanks again for the writeup. Have you found the outer boot has held up without performing the boot slide mode on the outer boot? I have not seen anyone mention sliding the outer boots, but it seems there is some slight rub of the baffles, although definitely not as tightly pressed together as...
Rolled edge cv clamps?
Thanks for the excellent writeup. Where did you find "rolled edge" worm style clamps? Seems like all the ones at the hardware store are square edged and have some tabs under the worm gear that look like they could cut the boot....
