Recent content by TripWire

Anyone seen any information or wiring diagrams on a "5 Button TDS" security system? Evidently, this was a dealer add-on to the 2000 Limited. All I can find is Main Module Part Number 00016-30988-01 and Immobilizer Compatible Remote Start Module 00016-30988-52 (Google returns nothing for these...

Exactly what I used. Don't try to penetrate the wire (you will slip and stab your hand). Push the needles in parallel to and beside the wire until they touch the metal contact in the receptacle on the other end. Before you connect the MAF sensor to the plug, test continuity to the metal...

I have a 2000 Toyota 4Runner Limited 2WD 3.4L. automatic transmission, and used the kit ND-36SOL. ND-36SOL Nippondenso Solenoid Repair Kit – Cpidivisions only shows 4 contacts and it is missing the offset contact that is shown in the ND-34SOL picture, however if you order direct from CPI you...

Door panel time. Ended up taking off all 4 door panels, disconnecting the actuators, and testing with 12v on each. They would work two or three times (reversing polarity) then slow to finally stop. Passenger doors worked better than the driver side doors. I read on other threads that as the...

Here is a pic of 1H connector for those who find this thread later....

Spent most of the day messing with this. Original problem was the "lazy locking/unlocking" on really all 4 of the doors. I started at the Body ECU because I initially figured the relay was the culprit (although it did have a strong click), but because the 1H connector fed both the coil and...

ok, I think I figured it out. The connector that comes from the door lock switches is actually labeled 1H. Ground 1H pin 10 and that energizes the relay coil and locks the doors. Ground 1H pin 9 and that unlocks the doors. Even matched the wire colors with the pin slots, so that correlates...

That gets me closer, but I don't see a reference to connector B16 on the Body ECU you posted on another thread, nor does the Body ECU have a connector with 23 pins on it...

IBall, thanks for posting this wiring diagram. However how do I match the connector on the Body ECU to the cowl wiring harness plug? Looks like the connector is labeled B16?