Recent content by Utahtoy

I purchased the Rokeman Off-Road lower rear control arms for my 3rd gen 4Runner 4 years back and I am looking to replace the bushings. Rokeman does not seem to be in business any longer. Does anyone know of what available bushings are available for them?

Do any of you guys have a second or third switch in your car that needs to be engaged/pushed to start your truck? I have seen quite a few stolen rigs and am considering wiring up something off of the fuel or ignition that needs to be separately engaged to start the vehicle.. Thoughts?

The contact points were messed up and got it fixed

Heater is fixed, the door was stuck and manually opened it until parts arrive. Thnaks for the help!

My rear E-locker is stuck on and engaged. I went wheeling a few weeks ago and noticed that it would not disengage. The E-locker light was blinking at me for a week or two and the light is no longer blinking or solid. Any ideas as if this is the actuator or possibly wiring?

Thanks for the input guys, motor is a 3.4L. The engine gets to normal operating temp quick so I doubt it is the thermostat. I am going to dig into the blend door in the dash as I cannot hear it move when I switch the climate control.

I believe the motor is broken since the hold/cold control knob is clicking. I already manually opened it and disconnected the cable from the unit under the hood. The only other thing I need to check is to make sure the flap in the dash is opening and closing of which it may not be because I can...

Hey guys, I am trying to avoid replacing my heater core. I noticed it would not blow hot air so I searched the forms and did some work before asking questions. What I have done: - Flushed heater core with water, it flows out the input or output side easily - Flushed heater core with CLR and...

How many coats did you do?

How do you like the tires?

3rd gen towing a small trailer.. occasionally my 1st gen for short distances

looks good besides the saggy butt

Sweet rig man

Awesome work!