Recent content by VegasT4R

Looking for a beige 2nd gen sunroof switch cover. Just need the cover, not the switch. Picture attached. Thanks, VegasT4R

2nd Gen Spark Plug Fiasco (V6) Problem solved. Dealer was able to see there was a previous repair on spark plug sockets #3 and #1. Technician was able to re-thread (heli-coil?) and repair the sockets, installed new spark plugs on all cylinders. Next on my list is accelerator cable...

2nd Gen Spark Plug Fiasco Thanks 91'4bee, Will check to make sure the size is correct again. I compared the three spark plugs I pulled out (Denso K16R-U) with the new NGK's, and they appear to be the same size. I also looked at the Denso's to see whether the previous owner had heli-coiled a...

2nd gen V6 Spark New Plugs Won't Install Bought a 1995 4runner V6 2wd earlier this month. Just over 200,000 miles on the clock. In pretty good shape, so I thought I'd take care if a minor tune-up this weekend. Got to the spark plugs and thought I'd start with the worst one, the last one on...

Brake Booster Leak? Agree with MacGyver1979. Check the brake booster. There might be a vacuum leak in the booster. You should be able to hear the slight vacuum leak when you apply the brakes. VegasT4R

Recommend you check your accelerator cable. There are usually three cables near the throttle body. Follow the one that goes into the firewall. Tighten the nuts of the accelerator cable near the throttle body to remove slack. Additionally, this cable is susceptible to a deteriorated rubber...

Just replaced my brake booster, so I replaced the master cylinder also. No leaks in the MC. Appeared to work before I pulled it. Non-ABS model.

Brake Booster and MC install Complete Installed the non-ABS brake booster and master cylinder without a problem. Brakes bled, reservoir filled. Test drive good. One side note: when brake booster is removed, the brake light switch should be closed or battery disconnected to prevent the brake...

ABS -Not Purchased master cylinder and power booster for 1995 4runner V6 2WD with ABS option. When compared to what is in the vehicle, the master cylinder does not match. Therefore, the vehicle must be non-ABS. Must return MC and booster for non-ABS models. Will get'er done this weekend...

Thanks for the reply DeciansDaddy -- thank you. Will look in the area you mentioned. Will have to get under there anyway, since I need to replace the exhaust also. Speaking of exhaust, anything I need to be watchful for? Planning to use stock exhaust, with new cat. Will have a local...

First, my apologies if posting in wrong area. Please move to different category if needed. Second, newbie on this forum, and appreciate all of the information available from experienced 4Runner brethren. Third, I just purchased a 1995 4Runner V6 2WD and need to replace the brake booster...