Recent content by Volcom

Just wanted to bump this thread. Was thinking and talking about you today Nick!!! I'll always remember the fun times we had wheeling together!

Perfect, thanks for the reply. The fuel is smaller than the transmission fittings. Maybe an M14 x 1.5? Amazon has the M16x1.5 to -6 fitting so that's promising.

Can anyone tell me the size and thread pitch of these transmission and fuel line adapters? Or the size of the lines? I am needing to adapt these to some -6an lines for my buggy [/url]IMG_3516 by VolcomCO, on Flickr[/IMG] This is the transmission line adapter IMG_3517 by VolcomCO, on Flickr...

TG coats them in some weird yellow crap. Probably so they don't rust on the boat ride here. Took some scrubbing to get it all off. TG adapter. Acquired it for free.99 from a good friend of mine. Wasn't complete so I had to buy some stuff from TG to make it work. I didn't know they had a...

Untitled by VolcomCO Prepping for motor mounts. Thanks for the help guys!! Untitled by VolcomCO Finally getting the engine into the buggy!! Untitled by VolcomCO Untitled by VolcomCO Joe built some factory style motor mounts for his project and couldn't end up using them. They worked...

Had to pull the t-cases apart to get the stock 21 spline input in the front reduction block out. Going behind an auto, it has to be upgraded to 23 spline. Untitled by VolcomCO Before the t-case surgery 21 vs 23 input by VolcomCO Little size comparison Untitled by VolcomCO After Untitled by...

The 4Runner ran before I pulled the engine but it ran poorly. Tons of white smoke out of the tail pipe. Figured it had a blown HG. Pulled the engine apart and got the heads off it. HG didn't seem to have any signs of a HG failure. Decided to have the heads pressure tested and they were both...

The plan for this F-Toy is to swap in a 5VZ and auto from a junked 1996 4Runner I picked up in a trade. My dual ultimate crawler setup behind all that and run my Tacoma width TG Rock Assault front axle and IFS width TG Rock Assault rear axle. Untitled by VolcomCO The donor, 196K on it...

Picked up the F-Toy chassis this summer Untitled by VolcomCO Untitled by VolcomCO Untitled by VolcomCO Untitled by VolcomCO Going to suck building a buggy in a small 2 car garage with too much stuff in it already This what it looked like right before he tore it down Untitled by VolcomCO

Got the opportunity to purchase a four seater Formula Toyota chassis from a good friend of mine. He took his engine, transmission, t-case, and axles from this F-Toy and is in the process of moving it into a Rock Lizard chassis. CO- Formula4 Build - Pirate4x4.Com : 4x4 and Off-Road Forum I've...

Good luck, Moab has eliminated a lot of the primitive camping around Moab.

3.4 feels like a rock ship compared to my 22RE with 39.5's :spit::spit: I've driven up I-70 several times in my 4Runner and up Vail Pass I'm in 2nd gear, pinned and holding 5K the entire time.

That's how shops make their money. They all do it.

How did that feel on Hell's Gate? I'm glad that was the worst of it and you didn't end up downhill.

I hope it doesn't affect their cordless tools as well. I'm balls deep in the new Kobalt 24v cordless tools. Impact, drill, circular saw, light, etc....