Recent content by wvjeepers

Is there any way to clean the IAC on these without destroying the sensors?

That will be fine

Gotcha.

pm me a price shipped to 25702. this drive by wire setup, is it cable assisted or something? there are cables that control throttle response. I just assumed they were actualy attached to the petal.

I have a 02 SR5, its running like crap again and throwing the code for the IAC. I understand the IAC is built into the throttle body and the whole unit must be replaced. I'm having a hard time finding a TB at local parts stores, and would like to keep the cost down as much as possible, so I'm...

went out and pulled the coil, cleaned it, but didnt notice any defects. wrapped the boot in a layer of electrical tape. No cel so far, seems to run good (other than a exhaust leak and heat shield ratteling). If this fixes it for good, I'll grab a boot later this week. Thanks everyone.

I didn't move the plug when I moved the coil, but the misfire followed the coil. Hadn't thought of the boot being bad, but there was condensation/light rust coke red dirt on the boot when I pulled it. Can the boot be replaced by itself without replacing the entire coil? I'm a cheapskate lol.

Toyota newb, been dealing with Jeeps all my life. Wife has a 02 SR5 with the 3.4, I was getting a cyl 1 misfire. Checked the injector with my mechanics stethoscope, and could tell it wasn't working. Replaced the injector, firing correctly (by ear), cleared the code, drove it around the block...