Ok here we go..
GoRhino 4" Oval 415 Series Steps. part# 67427T
Go Rhino
(no plastic caps, all welded ends)
I installed in 30min or so. I ordered them through AutoAnything Shipped for $196.
$500+ for Sliders was out of the questions and $300 for N-Fab that will only last a winter or 2 here...
I did a molle panel on my back door of the my FJ.
its easy to hold things for the trail or basic car stuff. Jumper cables, cleaning stuff, baby stuff. Anything.
Drove it today... No smell or a very very lite hint of it..
70mph 2000PRM, you can hear it not bad at all.
if your in your mid 30's you will be happy if your in your 40's its to loud. :pound:
Welding smell is already gone..
I don't know if this was brought up. On my 2006 Tacoma TRD Offroad had a 160 or 140amp Alt installed in it. It was the factory option for the Offroad.
Has one tried to install one of those? Or see if one would fit?
I was stuck in traffic for an about an hour. No smell..
For the plastic, I will trim that little think bit of plastic that hangs down. If I notice anything.
To low? Its tucked up more then a full side kick out. Also, maybe 10% of off-roading with the truck.
Chrome.. Ya no..
What I am...
Just had a muffler shop cut and weld in the 18" MagnaFlow 12256 muffler. Sounds great, I didn't take it on the HWY yet but the heavy traffic I was stuck in it sounded great.
I also had the guy move the tailpipe. The smell with the window open was getting to me.
(no videos or sound clips...
its done,
Pain the ass kinda.. I used a new wiring that I bought off ebay.
Ran power off the batter for the lights. For the on/off part of the relay. I jumped off the side marker light (not blinker). I then ran the negative power side wire into the truck and unhook the small fog light switch...