Recent content by Zal4R

So, I have had a front strut fail and am trying to determine the cause. Has anyone else had an issue with this and the Eibach Springs? I have not seen anything and am still doing research on the cause, but thought I would ask.

Yeah, my bad. I always go high.

Overall, my rack went up a little over an inch, since it is mostly in the back. The 285s will add another inch or inch and a half, depending on brand etc. You may want to change out the UCAs to be able to fit the tires better with more caster as well. I am still sitting at 22 from hub to...

Which Plano boxes are those? I have a trunk, but it sticks up pretty high. Fits all my camping stuff. My recovery gear is in the back. Would love to put the gear up top with a slimmer box and put the camping stuff inside.

What pressure are they at and are you carrying anything heavy? If my terra grapplers are below 34 they get vibration around 55-60. If we have stuff loaded for a trip, it’s 35. I usually chalk test the cold tires after loading to get where I need to. The tire pressure fixed a lot of my...

Saw a Tacoma winched out of a wash using 3 winches. One on the driver side frame, and 1 on each of the front recovery points at angles. No issues at all. Anything more would have required a toe truck or crane of some sort. I am good just using them as is.

So, if you get closer, it will actually brake. It will not completely stop though, had it kick in when someone cut in front of me once. For the cruise control, you can hold down the power button when you turn it on and it will let you use it in normal mode without the radar.

I will say it sagged about 1/4 inch 8n the front after tossing all of my aluminum plates back on. If I am remembering correctly it is 22 from hub to fender in front and 23 in the back. I should probably measure all 4 again and write it down. I am thinking about tires for when the time comes...

I would think you would need new UCAs at least. I am thinking that may be my next big project, since I cannot quite get the caster to spec (barely) and you would probably need more adjustment, possibly longer brake lines or abs cables, etc. definitely call Westcott. Also, stock tires (wife...

Got my springs in for my 2021 pro.. will be keeping my 265 nittos until they need replaced from wear. Haven’t decided between 275 or 255 for when they need replaced. I don’t mind the look, although slightly bigger will look better, it’s a work in progress. Cannot justify throwing out good...

Excited. Mine came in early. Got them today. Going on next week.

Has anyone who has had these in the past had needle bearing issues?

Luckily I have not had the needle bearing issue yet, but I also got the extended warranty (at cost) specifically for the electronics.

Fox recommends sending them in every 50k to be done and such. At least I believe 8 read that somewhere.

I just took the nut to Home Depot and got stainless bolts of the same thread and length I needed. I put my traction boards on with 5 inch and use 2 inches to go into the bottom of a Plano case I modified.