Recent content by zonzin

So basically the cooler is a "pre-cooler" as it cools before entering the radiator cooler. .

Yeah because it does not go away in 4hi on mine I'm looking into wheel bearing failure. Researching now. .

Installing Ride Tech sway bar bushing and Icon relocation block did the trick for me. Here's a thread for pics and writeup Review, Ride Tech Delrin Bushings and Dirt King LCA's Here's the block Amazon.com: Icon Billet Aluminum Sway Bar Relocation Blocks Kit 611030: Automotive

It has 90,000 on it, mobile one 75/90 front and rear diffs, changed every 20,000 . Drive shafts lubed every 5,000 transfer case changed every 20,000 with royal purple. Alignment done dead on. Maybe it is the needle bearings and mine just presents it a little different than everybody else's...

Yes they are. .

Recently my 4runner has been making a low frequency pulsing noise peaking at 40 mph. It is very pronounced and clocks at 80 decibels , 20 above normal ambient driving noise. At first I thought it was the dreaded needle bearing issue but this noise does not go away when in 4H. In fact, it...

Hauling my 2000lb Camplite.

Measure twice, drive in once. .

Consider a frameless mirror, they look so much "cleaner" On Amazon

Anecdotal evidence: Installed 255x80's and picked up 1.5 mpg over the 285's. . .

Nice solution. Ordered.

Don't know when it was added but Toyo now has Pizza Cutters in the III. LT255/80R17 121/118R E BSW - 355750 6.5-7.0-8.5 .

The FJ would be the competition for the Bronco, not the 4R, if Toyota brings it back. Heck, the Bronco kinda looks like an FJ. .

Seems impressive, but it's still a Ford. <iframe width="596" height="335" src="https://www.youtube.com/embed/onsPobKT6xc" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> .

it's functional, catches bugs like nobody's business. ,.