Recent content by ZoSoIV

My FJ was antifreeze but I’m the only one I know of that’s happened too

Leaking oil or antifreeze?

CS641 - 4100 Series 6 1/2" Component Set Mini P400.4 Amp 12" 1100 SERIES Subwoofer All Brand New Never Installed Full 2 Year Warranty..Very High End Rock Solid Gear Guys all you would need other than this is a good 4 volt preout headunit (Alpine/Pioneer....all total would retail for...

Yes all the above , the inside of the door around the driver and the outer door , a good rule of thumb is to use about 10 sq ft per door ... I used 25 sq ft per door on my FJ

It looks ok , I use the Rattle Trap 80mm thick and a lot less expensive than Dynamat you can get it on eBay or Amazon or direct

You might try some tuning to get more low end out of them plus sound deadening the doors would help a lot

Cool yeah looks like the old drivers have seen there better days , how do the new drivers sound ?

I found the stainless steel for 129.00 for the FJ

I'm getting the stainless steel lines for my FJ

The 4th gen 4 runner should be a 338mm rotor and the 5th gen are 338 also so the sheilds should be the same ... unless you would happen to have 319 mm rotors which is possible ... the only difference in the 4th gen compared to the 5 gen is the thickness of the rotor 4th gen is 28mm 5th gen is...

cool no problem man, glad to help actually the build quality looks pretty good on those components you bought for the money,let me know how they sound once you get then in .. when you get ready to do a system in son's Honda PM me i can help you out i just put a killer JL system in my Honda Civic...

yes you will be ok via 50 watts will run about any components fine ...These Image Dynamics are really great component speakers for the money if you decide to go new drivers 169.00 IMAGE DYNAMICS CTX65CS 6.5" PRO COMPONENT SPEAKERS MIDS CROSSOVERS TWEETERS NEW | eBay

ok i will look for it

Yeah it sounds like you don't have components setup that come with a crossover network... so just make sure when you get new tweeters they have a inline crossover (most do) then make sure your sensitivity on the amp isn't set to high on tweeters and you should be fine ... over driving them...

ok to be clear are your speakers components speakers (midbass and tweeters with a crossover) or are you running full range 6-1/2 speakers in your doors with tweeters in the dash? if the later you need a inline crossover on the tweeter...just making sure your setup is correct ...a couple other...