Toyota 4Runner Forum - Largest 4Runner Forum

Toyota 4Runner Forum - Largest 4Runner Forum (https://www.toyota-4runner.org/)
-   3rd gen T4Rs (https://www.toyota-4runner.org/3rd-gen-t4rs/)
-   -   3RZ vibration at around 2000 rpm (https://www.toyota-4runner.org/3rd-gen-t4rs/278319-3rz-vibration-around-2000-rpm.html)

eurasiaoverland 10-05-2019 02:51 PM

3RZ vibration at around 2000 rpm
 
Hi guys

3RZ-FE, 5 speed

Thanks to posters on here, I tihnk I have found the source of one of my noises (front diff CV carrier bearing - new ECGS bushing in the mail!).

But I have an engine vibration which is separate from any driveline / road noise.

I should say first that my engine runs really nicely, no oil consumption, good fuel economy etc. Valve clearances are spot on. The engine was rebored and rebuilt (by me) about 30,000 miles ago, so I have a feel for which components are possile culprits (things I did not replace at the time).

Anyway, my vibration starts at around 2000 rpm and I can feel it through any hard part of the vehicle I think. I think it's just the natural vibration of the engine, but it somehow feels a bit too strong to me (maybe I'm being paranoid - it is a 4 banger after all). It does it when the vehicle is stopped and in neutral, clutch in or out.

The engine mounts were new and look fine, thoug I do notice the rubber is dark from the vibraiton (i.e. the rubber is moving, so that dirt / dust do not crust up on it, which it ould do if it was static). The transmission mount is original asfar as I know, but I cannot bring myself to replace it as it looks and feels fine - the rubber is still soft and the two parts of the mount are kept off each other.

The injectors were replaced about 15,000 miles ago with brand new, genuine Toyota parts. During the rebuild, the head and valves were all replaced with genuine parts and the block was machined so I can't believe that I have serious cylinder pressure issues (though I have not checked). I do plan to run some injector cleaner through it, but somehow I doubt it will do much. The engine is as clean as a whistle inside.

The only cuplrit I can think of is the harmonic balancer, I can't tell if it is running perfectly true (there might be a slight wobble, or it might just be different patterns in the rust on the item) but it's certainly not badly off centre. I do have a new one here with me, which I plan to fit.

Does anyone have any other ideas? Antyone had the same problem?

Thanks

EO

zcrew 10-05-2019 09:27 PM

Once you get above 2k RPM does it fade away or get worse?

eurasiaoverland 10-06-2019 09:54 AM

Quote:

Originally Posted by zcrew (Post 3367287)
Once you get above 2k RPM does it fade away or get worse?

I would say it gets less, but does not go away

austindenny 08-01-2020 05:36 PM

Quote:

Originally Posted by eurasiaoverland (Post 3367413)
I would say it gets less, but does not go away

curious about whether you ever resolved this issue? think I’m experiencing something similar in my five-speed. I feel it most through the floorboard but might also just be paranoid after having just replaced the timing belt, etc. didn’t notice anything really odd during that process; about to replace the mounts, which will hopefully do away with it. might also be referring from unhappy u-joints after a few thousand miles of procrastinating on the panhard correction kit? who knows

eurasiaoverland 10-13-2021 12:51 AM

Quote:

Originally Posted by austindenny (Post 3526496)
curious about whether you ever resolved this issue? think I’m experiencing something similar in my five-speed. I feel it most through the floorboard but might also just be paranoid after having just replaced the timing belt, etc. didn’t notice anything really odd during that process; about to replace the mounts, which will hopefully do away with it. might also be referring from unhappy u-joints after a few thousand miles of procrastinating on the panhard correction kit? who knows

Sorry for my late reply. I have not seen my Hilux Surf (4Runner) since January last year.

Shortly after posting this, I replaced both the harmonic balancer and the fluid coupling with new originals and it improved the problem. The rest I put down to just being a 4 cylinder engine. Let's see when I hopefully get back to the vehicle later this year.

Regards your above comment - one thing which would be 'really odd' would be finding a timing belt anywhere in a 3RZ.

EO


All times are GMT -4. The time now is 01:20 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
***This site is an unofficial Toyota site, and is not officially endorsed, supported, authorized by or affiliated with Toyota. All company, product, or service names references in this web site are used for identification purposes only and may be trademarks of their respective owners. The Toyota name, marks, designs and logos, as well as Toyota model names, are registered trademarks of Toyota Motor Corporation***Ad Management plugin by RedTyger