Toyota 4Runner Forum - Largest 4Runner Forum
Page 1 of 2 1 2
Show 40 post(s) from this thread on one page

Toyota 4Runner Forum - Largest 4Runner Forum (https://www.toyota-4runner.org/)
-   4th Gen T4Rs (https://www.toyota-4runner.org/4th-gen-t4rs/)
-   -   4th Gen Cat Back Exhaust Replacement Recommendations (https://www.toyota-4runner.org/4th-gen-t4rs/296199-4th-gen-cat-back-exhaust-replacement-recommendations.html)

rwh963 03-29-2021 02:34 PM
4th Gen Cat Back Exhaust Replacement Recommendations
 
well, my pipe just broke after the muffler. think i will need a full cat back replacement (two pipes: muffler and resonator). prefer to stick to OE (have a WTB/FREE ad running), but those two sections from Toyota will run $600! I don't like cheap "aluminized" Walker junk that rusts out one day after the warranty.
Recommendations?

Warwicke36 03-29-2021 02:55 PM
I got a Gibson sainless on sale for like 375 for the sole purpose of avoiding rust.

My buddy found an OEM style stainless on Amazon for pretty cheap.

So there are options.

Tomm- 03-30-2021 04:07 AM
I was sold on Remark Bold Performance. Not a lot of people have it but the quality is outstanding.

Bold Performance by REMARK - Toyota 4Runner ** ETA End of April **



– REMARK USA

JONBOY345 03-30-2021 08:07 AM
I've been pretty pleased with my Magnaflow cat back.

If I were to do it over again, I would have gone straight to a 1/4 Wave Resonator to kill the drone at 1800-2100 RPM, but otherwise no complaints.

Best-looking side exit exhaust available as well, IMO.

Gibson side exit tips look goofy as hell.

Drcoffee 03-30-2021 09:30 AM
So back in 2014 I put a borla TRD exhaust on my kids 99 4runner. Worst waste of money I had Spent on the truck. It had a drone at 45 & 65 mph that would scramble your brains. After some searching, I found a member who fixed it by installing a tundra resonator after the muffler. And thats what i had to do to mine. There is no substitute for a nice quiet ride. I just wish there was an option for a stainless setup designed for quiet running.

rwh963 03-30-2021 12:01 PM
isn't the original a stainless set-up, and quiet? went to my local independent exhaust repair shop. they think they can cut and weld a flange/pipe piece for $80. they said it should last a year or so. might buy me time to locate a nice 4th gen. OE take off that someone has hanging from their rafter.

rdruss 03-30-2021 12:23 PM
Quote:
Originally Posted by Tomm- (Post 3621920)
I was sold on Remark Bold Performance. Not a lot of people have it but the quality is outstanding.

Bold Performance by REMARK - Toyota 4Runner ** ETA End of April **



– REMARK USA
How would you rate the around town and highway cruise noise level on Remark? Does it drone?

rwh963 03-30-2021 02:23 PM
deeper research into my repair history indicates that i replaced the muffler and resonator pipes in February 2018 at 195k. so got 25k out of them. not good. they must have been the dreaded walker aluminized pipes. i think i will still sink the $80 into a patch, and cross my fingers i can find a nice take-off.

Tomm- 03-30-2021 05:04 PM
Quote:
Originally Posted by rdruss (Post 3622030)
How would you rate the around town and highway cruise noise level on Remark? Does it drone?
I don’t hear it over my MTs unless I’m 50% throttle or higher. No drone. I’m running stock headers, stock y and the Remark catback. My DT long tubes will be here this week so that might change.

Heffernan 03-30-2021 09:48 PM
Quote:
Originally Posted by Tomm- (Post 3621920)
I was sold on Remark Bold Performance. Not a lot of people have it but the quality is outstanding.

Bold Performance by REMARK - Toyota 4Runner ** ETA End of April **



– REMARK USA

That nice, price isn’t bad either. I might have to keep this on my radar.

rwh963 03-31-2021 09:24 PM
does 5th gen. cat back fit 4th gen?

Eugene13 03-31-2021 10:56 PM
I got a gibson catback exhaust back in September, stainless steal straight exit. Sounds great, nice growl at low RPM and open up at high RPM.

Tomm- 04-01-2021 04:08 AM
Quote:
Originally Posted by rwh963 (Post 3622707)
does 5th gen. cat back fit 4th gen?
I've heard mostly yes but few people have validated it. What year/motor are you running?

rwh963 04-01-2021 08:01 AM
Quote:
Originally Posted by Tomm- (Post 3622834)
I've heard mostly yes but few people have validated it. What year/motor are you running?
2007 V6 4wd. if it does, i can expand my take-off search to the 5th gen.

Tomm- 04-01-2021 08:42 AM
Quote:
Originally Posted by rwh963 (Post 3622857)
2007 V6 4wd. if it does, i can expand my take-off search to the 5th gen.
This guy put a TRD Pro exhaust on his v6 4G: 5th Gen Exhaust on 4th Gen?


All times are GMT -4. The time now is 04:16 AM.
Page 1 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
***This site is an unofficial Toyota site, and is not officially endorsed, supported, authorized by or affiliated with Toyota. All company, product, or service names references in this web site are used for identification purposes only and may be trademarks of their respective owners. The Toyota name, marks, designs and logos, as well as Toyota model names, are registered trademarks of Toyota Motor Corporation***Ad Management plugin by RedTyger