Traction Control/VSC problem
I just bought a 2001 4runner which drives great until I took it up paved canyon roads with twisty turns. When transitioning from turn to turn, (right-left, left-right) my traction control starts beeping although I have full traction, then it locks up my front brakes (more heavily on the right).
This is dangerous and probably shouldn't drive until I find a fix, but I will be moving soon and need the car. Thinking of doing the andy-mod without a switch until I can get one. Essentially just cut the wire and leave traction control off. Will this prevent my traction control/VSC from locking up the brakes? Will cutting the wire and not adding a switch mess anything else up? Also: no lights on dash (TC,VSC, engine, etc) until I make above mentioned turns and TC light turns on and beeps Will also try zero point calibration and see if that works. Some other things: -car is completely stock, previous owner said he never put lift or any other mods -166,000 miles (maybe shouldn't have bought with so many miles but I like the 3rd gen) -took it to get an alignment, came back with the alignment worse, steering wheel 5 degrees to the right. Noticed TC issue before alignment though -little bit of play in the steering wheel, but still responsive and turns great until TC kicks in for no reason |
The quirks of VSC and TC in the 01-02's. Could try recalibrating VSC or go with the Andy Mod 2.0
I have done both Andy Mod does the trick. Lots of Info to read to understand how system works How-to's on both in forum. 166k mi is nothing for a 3rd Gen. |
Quote:
I think I saw on youtube where a guy just unplugged something from the master cylinder for a temp disable Sean did a nice video on this mod and its listed under his and timmys videos |
And there is the case where a forum member said it caused his rollover in a turn rearend got squirrely on gravel as story goes.
|
@MIC_uhh
, Suspension height gets system out of calibration through age sagging or lift install.
At 166k mi depending on how it been used I'll bet it starting to sag VSC could be getting sensitive. Check this out. 01-02 4Runner How to Zero Point Calibrate your VSC system. - YotaTech Forums |
Quote:
Thank you for your response, it gave me some reassurance. Let me know what you think about just cutting the wire without installing switch for now. I'm not to good at electricals so it feels like I'm trying to diffuse a bomb :crazy: |
Quote:
I also saw a video on YT of a guy unplugging the whole connector from master cylinder. I can't find it again but seems simple enough that I could just go off memory and try it tomorrow. |
Quote:
|
bearings
Something I forgot to mention is that my front bearings need replacing, and within the next 2k miles my rotors and brake pads. This could be contributing to my TC getting triggered.
Until I find the time, the Andy Mod seems like the way to go for now |
All times are GMT -4. The time now is 10:56 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Search Engine Optimisation provided by
DragonByte SEO (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
User Alert System provided by
Advanced User Tagging (Lite) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
***This site is an unofficial Toyota site, and is not officially endorsed, supported, authorized by or affiliated with Toyota. All company, product, or service names references in this web site are used for identification purposes only and may be trademarks of their respective owners. The Toyota name, marks, designs and logos, as well as Toyota model names, are registered trademarks of Toyota Motor Corporation***Ad Management plugin by RedTyger