I tried to do something with my 2011 SR5's power lock on the driver's side front window/lock controller, more specifically the wiring to it. Without getting into detail why or what I was trying to do, I made small wire insulation openings to access each of the copper wires. Visually it does not look like I cut the copper at all so continuity should still be there. So, I wasn't able to do what I set out to accomplish, i covered the exposed copper with Plasti-Dip to re-insulate them separately. Now, my driver door window and lock buttons don't work. Neither does the rear window up/down switch work, which I never touched. I believe I covered and checked all the fuses that may have blown associated with window operation. I bought a new driver's side window/lock up/down switch, but it still doesn't work. I'm going to re-check wire continuity and power tomorrow. If anybody has any other ideas of what else may have happened, I'd appreciate to hear from you.