Aftermarket crossbars (stock rails) Load out - picture request

[bigdaddy2021]

Searched a bit for a dediated thread and didn't find one. I have an LFD setup ordered at this point including their hi-lift mount and i also picked up a set of maxtrax pins to secure my traction boards. I'm looking for load out examples of how you're loading your Artec/LFD/Rago Fab or other aftermarket crossbar load system.

Love to see pics of your setup. I'll post mine up as I go along.

We have Victory4x4 bumpers on order, and COULD add swing-aways at some point, but man, we really like being able to just swing the hatch open w/o extra steps, so we're focused on using the rear cargo area and roof as much as possible for our gear for an up-coming Moab trip.

 

[bigdaddy2021]

This is from the LFD site - shows several possible loadouts:

Cargo tie downs
Traction board mounts
Two Rotopax mounts on the wide ruggedized bar (which I'm assuming could hold a single long container, if needed?)

 

[bigdaddy2021]

Here's one with a normal loadout from what I've seen (though it seems like an older gen, maybe without slotted rails? )

 

[bigdaddy2021]

Here's a set of artec bars holding traction boards and the seemingly ubiquitous rifle storage case. I'm assuming you can just drill through the box, seal with some silicone and bolt directly to the bars?