HELP: rear license plate relocation - wiring

[Ducks & Trucks]

Ive exhausted myself trying to find some answers.

I relocated my rear license plate due to my cbi bumper. I got A new set up from ORW but it didnt have any instructions. I also Can’t find the tail light wiring diagram.

Can anyone steer me in the right direction?
I need To know which wire to tap. And how the hell to wire it. Pretty sure I’m splicing into the tail light, unless there’s a way to reroute the original license plate wiring?

 

[V8Man]

[MENTION=148374]Ducks & Trucks[/MENTION]
Go to the trailer hitch plug. Just in front of it are the wires and connectors you could tap into.

 

[blackoutt]

Ditto, I would just tap into tail light power via the trailer hitch wiring.

 

[JM1914Tn]

Bump

How did you end up wiring this? I’m at the same point and need some input

 

[1G3runner]

I realize this is 4g but does anyone know of a solution to not have the brake light blink when signaling?



Looking at the pin out, you have to choose either L or R signal off the trailer wiring as they’re paired with brake.

 

[mochacho]

I got an 80% offroad carrier. I hate getting pulled over for dumb things so opted to relocated the plate/light to the center of my spare. I bought an amazon plate holder/light combo meant for a Bronco. I spliced into the wires in my hitch/tow package and ran it to the plate with a single +/- disconnect so I can remove it quickly if I ever need to use my spare.