Weigh in on my panhard

G_Raw · 2021-05-16T15:48:23+00:00

Hey folks I get a random vibration at shift points. So basically at 1800 to 2500 rpms depending on my driving. It's happened since my lift. I've gone through 3 drive shafts. My stock 2wd was fine when i killed it but i put a different stock 2wd shaft in just to see if it would change. It didn't. I then completed my 4wd swap so now I'm running that driveline. I've pulled my rear third ( regeared) and put my stock third in and it only changes at what rpm and speeds the vibration is felt. I'm wondering if my rear axle is slightly off causing a wierd angle on the drive line that I can't see with my brakes eye. My axle appears centered to me but my pan hard isn't horizontal. Do i need to extend my pan hard more you think?

Thread starter G_Raw
Start date May 16, 2021

G_Raw

New member

Jun 8, 2021

Sorry folks... took a bit to get the arms. They were back ordered. Then had family visiti mg. But I swapped em out today. Feels better but vibes are still there. Got them on to late to do a freeway run to really see how bad they still are but I'll do that tomorrow once morning traffic dies out.