Late night wiring projects call for a beer!

I finally found a way to keep the wiring on the swing out neat and durable. I ran the wiring through some fuel line with the soldered connections in the fuel line for protection. Then heat shrink over end of the fuel line (and of course over the soldered connections inside). I picked up some 1/2" conduit clamps this morning and used them to secure the line in place. I had to use some more fuel line over the existing line to make it large enough for the conduit clamps to actually clamp.

It all runs in below the taillight (there is a gap on the inside) where i was able to easily connect into the lights for the license plate light and then Aux light runs into the cab through the grommet.