Quote:
Originally Posted by D Farms
basically:
hammer out old stud
position in new stud, make sure the splines line up.
on the stud side put washers a lug and a bit of oil on the studs threads and the washers.
use an impact gun to pull it through, this will ensure that its straight as well.
|
This worked fantastic! Thanks so much!
Old stud hammered out (with new stud next to it):
(I noticed that the new stud has much shorter splines than the old one.)
The setup for the impact gun to pull the new stud through:
I didn't get an after pic, but everything is back together and I have 6 studs and lug nuts holding my wheel on again.
