Prev
PCV valve replacement, old one has dry rubber ring which cracked off the old grommet... that ain't an o-ring i mistakenly thought it was for a sec! he
Next
Prev
ignition side of steering column, tilt mechanism and linkage being cleaned and greased (tilt lock started slipping rather than locking in place which
upper u-joint area of steering column, fouled up pretty nasty but getting cleaned and regreased where needed.
PCV grommet
PCV valve replacement, old one has dry rubber ring which cracked off the old grommet... that ain't an o-ring i mistakenly thought it was for a sec! he
belts slightly frayed and super dried out with cracks, swapped out with some complications but can now be done very easily in minutes
passenger window gears, levers and lock linkage/mechanisms cleaned and treated with lithium grease but need to go back and use heavier duty grease on
some new vac lines, cap & rotor, NGK plugs and wires, and fresh coil. desperately need to replace dry rotted intake tubes
Next
L

PCV valve replacement, old one has dry rubber ring which cracked off the old grommet... that ain't an o-ring i mistakenly thought it was for a sec! he

  • Media owner LouRadon
  • Date added
There are no comments to display.

Media information

Album
R.Studios '87 4Runner - repairs & maintenance
Added by
LouRadon
Date added
View count
0
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Members online

No members online now.
Total: 5,355 (members: 0, guests: 5,355)

Forum statistics

Threads
278,315
Messages
3,554,125
Members
248,016
Latest member
Advally Service

Share this page

Back
Top