Recent content by 08t4rUR

  1. 0

    Windshield Visor?

    Does anyone make a windshield visor for our 4runners?
  2. 0

    Leaving AC on when turning off engine?

    No, he has a Ford f-150 and his last truck was a ford as well.
  3. 0

    Front of seat too low

    Well, i was able to get 5 washers under the front mounts to give 3/8" of lift and the seat angle is much better. Due to the mounting design i couldn't go any higher than that without notching the rear bolt holes to allow the whole seat to go further forward. I'll try it at this height for a...
  4. 0

    Front of seat too low

    Thanks Fellas. I was hoping to raise the front about 1 inch. i'll give it a shot.
  5. 0

    Front of seat too low

    I have an 08 Urban runner with the alcantara covered seats and when raise the seat up past half way the front of the seat stops rising. So, the higher you raise the seat the more it slopes down in the front. I was going to make spacers for the front mounting bolts of the seat to tilt the seat...
  6. 0

    Leaving AC on when turning off engine?

    Ha, you are right! The guy is a "know it all" type guy but, i don't let it get to me.
  7. 0

    Leaving AC on when turning off engine?

    Thanks for all the responses. A friend of mine was riding in my 4runner last week and noticed that i left the ac on when i turned off the engine and said that it is not good to do and i had never heard that before so, i thought i would ask.
  8. 0

    Leaving AC on when turning off engine?

    Is there any harm in leaving the AC on when you shut the vehicle off? Does the AC clutch automatically release when the engine is turned off?
  9. 0

    Low milage problems with 2008 V6

    I have a 2008 4runner that i bought new that currently has 47,000 miles on it. I have only had 2 problems. 1) I had to replace the gas cap (i read somewhere that they only last 5 to 6 years). 2) 4wd problem.. even though i exercise the 4wd and transfer case often i had a hard time getting...
  10. 0

    ODB2 readers -- what to get?

    Can you actually clear the codes with the harbor freight scan tools or just look at them?
  11. 0

    Seized into 4W low. New actuator needed? Who's at fault?

    Has anyone ever tried heat to unstick the actuator? You could use a heat gun and get the actuator to about 200 degress and that might allow it to move...
  12. 0

    Generation comparison

    I went from a 2000 Jeep Cherokee Classic (Great vehicle) to a 2008 V6 4Runner (Urban runner) and it is a nice machine. I have a 2004 Mustang GT as a weekend car and it used to be a treat to drive the Mustang on the weekends after driving the Cherokee all week but, after driving the 4Runner the...
  13. 0

    Hankook ATM 255/70/18 4th Gen pics

    I have about 1,200 miles on them now and I am happy with there traction in wet and dry. If I have the windows down and the radio off I can hear the tires a little but, nothing annoying just a little reminder that I have some off road traction available when needed. :-)
  14. 0

    Hankook ATM 255/70/18 4th Gen pics

    Post a pic on this thread if you get a chance. I wish there was a Hankook ATM thread when I was looking for them. How often are you rotating them? Are they feathering much?
  15. 0

    Hankook ATM 255/70/18 4th Gen pics

    Looks good Mytoy4. I didn't know that some sizes came with white letters?

Members online

Forum statistics

Threads
278,309
Messages
3,554,075
Members
248,016
Latest member
Advally Service
Back
Top