Recent content by 1996T4runner

From rough estimates, looks like I'll need around 8 feet of wire from battery to fuse block. Wires from fuse block to sockets will be only a few inches. So from the wire calculators I've looked at 8awg should be enough to handle what I wana do. Since like you said each 12v will be 10 amps and...

Yea I was only asking whether it was safe to replace stock 12v that has a fusible link, with an aftermarket one that doesn't because i replaced my stock one with a voltage meter that has 2 usb plugs for my phone. Want to make sure I'm safe not having that fusible link anymore

Thank you for info. I am planning on running them with no switches, straight to fuse block which im planning to have under/inside center console. And then one 10awg or 8awg (not sure yet) going through firewall to the circuit breaker, and then to the battery. I would like these sockets to...

Would it be unsafe replacing the stock socket with a fusible link, with an aftermarket one that doesn't have a fusible link?

So I am pretty new to doing my own electrical and have done a fair amount of research but wanted to make sure im doing it right and have a question. I recently did a 99+ center console swap on my 96 4runner. And the center console i got had rear heat but my 4runner doesn't have it, so I want to...

4 runners are hard to come by around where I live. I have been looking, but haven't had luck finding a half way complete runner yet. Or I have found 1 or 2 but they are 96-98. Need a 99-02

Looking for the lower center console bracket. The center console bolts onto it from the inside compartment.

I know its a long shot. But do you have the lower center console bracket. I just need the bracket. Shipped to 93727. Can send money today if you have it.

Bump, still looking

Doing a center console swap on my 96 4runner. I got everything from a guy except the lower bracket for the center console. Lmk what you have

I am also in need of a center console bracket 99-02. I just bought a center console, it didn't come with the bracket. Do you by chance have anymore?

Damn well i feel your pain, I have a vibration and steering shake from 45-60 that i can't figure out. It was never there until I put king shock on, jba upper control arms, and new lbj. I want to make a thread about it, but havent done enough replies to allow me yet.

Hey im looking at getting wheels for my 4runner but can't figure out if they will fit. No info on here about them fitting 3rd gen 4runners Black rhino stadium rims 6x5.5 lug 16x8 -10 offset 4.11 BS I'm looking for rims that DONT need spacers to clear brakes, AND give a little poke from fender...

Will definitely have to do this after i finish everything on my front end

For the vibration problem, as someone said earlier, it could be a stuck caliper piston. Just jack front end up and spin the tires, see if one spins less than the other.