Recent content by 214RUNNER

I think that piece is just like an over lay with double stick tape & fits over the chrome. Not sure of the chrome piece is an overlay you have to see of the new piece fits over it, if not look close at the chrome section it might be an overlay with double stick tape also. You can do a vinyl rap...

Yes 2.5 front 3 rear and have the Panhard correction on rear diff.

I was looking for some thing with a thicker than stock tube for a little more strength. i was going to get the Apache Off Road one but the tube length is longer than stock.

Does any make a upgraded stock length panhard bar for 5th gen T4R? I only see adjustable panhard bars & a fixed extended length panhard bar from Apache Off Road.

Do you have the original window switch? try switching that to the new door maybe a bad window switch in the new door.

PM sent Scangauge II, $50, Houston

It looks like you have the suspension hanging try it with the jack under the lower control arm. The axle is lot level from what i could see at the end of the video. The axle should be level or close to it if not the bearings in the axle might bind a little at full drop. That sounds like the axle...

Use a open end wrench

check it first, if it’s that bad you might need a wheel bearing also

Did you check if the axle nut is tight?

hitting curbs , curb rash from parking to close to a curb

PM sent for 10 year 100,000 mile

Any one have a SP9100 melt between the positive post and the large wire harness, the negative pin melted out of the module and is stuck in the wiring harness connector. I had this about 1 1/2 years with no problems, all the connections were good I OHMed all the wires & checked out good only the...

No chose for different colors red & white & I would think about getting a set.

PM sent