Recent content by 4RunnerFJ

UPDATE: I installed a new cabin temperature sensor and there was no change. My next option is to take it to the stealership and ask them to take a look at it. My gut is telling me it's in the controller but I'm holding out for a loose wire somewhere. Fortunately, it hasn't been that cold around...

I'm going to check my cabin temp sensor sometime over the next week, I hope. I *thought* I had looked at it a while back when I was in there for something else and everything was connected. We'll see. I will update after I look. I refined my search after my post and found others had the same...

UPDATE 2/19/19: I installed a new cabin temperature sensor and there was no change. My next option is to take it to the stealership and ask them to take a look at it. My gut is telling me it's in the controller but I'm holding out for a loose wire somewhere. Fortunately, it hasn't been that cold...

It could be the servo. I had the same issue last year. That buzzing was annoying as hell. My problem was with the servo for mode (the one that changes which vents the air comes out). The servo is located to the left of the blower motor above another servo. Since it's easy to do, I recommend...

No, it never did pull out away from the dash. I was able to only move it towards the passenger side about 1/8 to 1/4 inch. It is still sealed. After a few days of use now, everything seems to be working as it should with the exception of the recirc servo. I was able to remove the forward screw...

So I never was able to pull the blower assembly. As you wrote in your instructions, it has to be either the claw or its getting hung up on the screw located at the lower right. I was able to move the assembly over just far enough to get my hand up in there to that one screw and replace the...

This is a great write up! I am replacing the air-mix servo (and possibly the fresh air/recirc air servo). I need a little guidance. What is the orientation of the claw that is referenced in the instructions? It's not the same one that resides on the left side of the blower housing is it (near...

Was this only for the fronts or all 4?