Recent content by 4X4T4R

I'm running the +0 springs on my rear load levelers. I have no rear added weight. Most of my weight is centered, full rack, full skid and sliders. At the lowest setting I was at stock height. If I remember correctly I went up 2-3 turns and went up about 1/2". I've got plenty threads to go higher...

Posted on their IG a few days ago.

You catch a peek of their UCA? Hopefully for the 5th gen!

Date code says "2020" which is 20th week of 2020

Very even depth. I've rotated them twice since new.

Sold

haha

How would you feel if Toyota followed Ford and spread the 4Runner name across completely different platforms? Would it take something away from the 4Runner models we now know? Would it make you take the Rav4 a little more serious? 4Runners have been somewhat consistent from Gen 1-5. Broncos on...

Yes I adjusted without removing. The trouble is they come preset for so much lift there's a lot of tension on that spring/ring. You need extend as much as possible by jacking up the front end. I didn't have to, but you may want to disconnect the sway bar, it looks like you've done that during...

Mine was the same after install too. I ended up at 6 full turns down to get it level. Jack each side up and be sure to mark the ring to keep track of turns. I had good luck with the silver/red handle eibach spanner wrench. I’ve had no “settling” with the front coilovers in 6 month. It did come...

Works fine no issues. I left one bar off so the sunroof isn't blocked. This picture is before I put the front rubber edge trim. I had much better luck with noise after installing the trim. It's surprisingly quiet.

The side plates are 1/8" thick aluminum. It's formed into a upside down "U" channel. This design is much more rigid than the flat side plates you see on other racks. The crossbars are regular 1x2 t-slot extrusions. The front deflector and rear piece are both formed from single pieces of sheet...

I saw your post on another thread and left the rubber off. Noise wasn't not bad at all, except the first crossbar would resonate loudly at 70-80mph. The rubber trim got rid of this. I also installed some clear film across the front. It only takes a strip about 2.5" wide. I just installed this...

Read through this thread. A few of us out posted our experiences. Eibach 5th Gen 2.0 Coilover Kit Agreed, adjusting down before installing would be a good idea. The trouble is having solid way to hold onto them. If you've got a good size vise mounted to a heavy bench possibly? I didn't have...

Amazon.com: HIGH FLYING For Toyota 4Runner TRD 2020 2021 Car Accessories Front Middle Grille Center Grille Inserts Cover Trims ABS 2PCS (Matte Black): Automotive