Recent content by 7104R

Sorry for the late response, yes the coils are black not the silver 1" ones. Thanks!

Thank you

Wheeler's T13 Rear Coil Spring Pair for 10+ 4Runner That's the exact coils I have in the link, I don't have pictures of my actual coils at the moment but I can show you how it looked on my rear. The picture by the beach is on 35s and other picture is on ~32s.

WTB: Hatch ladder for 5th gen / Wheeler t13 springs for sale. I'm looking to buy any hatch ladder in any condition,I just don't want to wait weeks for a ladder. I'm located in So-Cal and could pick up any where in So-Cal. I also have a set of Wheeler's Eibach T13 rear springs 1.5" lift for...

Here's my runners current form.

I apologize in advance if this has been asked but I have had no luck searching it up, are the OEM rear 5th gen springs L&R side specific? I took my OEM springs out to replace with wheelers t13 but now I'm going with a fabtech 6" rear lift and that calls for the OEM springs. Here's a pic of my...

WTB: Bushwacker pocket flares! (Paintable) WTB: front/rear Bushwacker pocket flares for 14+ 4runner. I can pick it up if you're located in southern California. Please PM!

Moved up the bumper support bar Moved up the bumper support bar and reinstalled 6 of the 8 screws instead of 4 as suggested, the extra 2 however are just sort of wedged on the edge of the bracket not in any of the holes and are just on there for my peace of mind.

Yea I did do it my self with pneumatic tools and snap on and it still took me about 5 1/2 hours to complete. Maybe it's because it's my first body lift but it was pretty time consuming for only 8 mounts. I didn't get the chance to take any pictures but it's pretty straight forward, if you look...

I think I'll have to move it up, just noticed my bumper popping off around the headlight area.

Hey all, just needed an opinion I just installed a 1 inch body lift from toytec on my 2016 sr5p and put on my front bumper cover without moving the bumper support up as suggested by other 5th gen owners with a body lift. I did notice I had to use a little more strength to get screws to line up...

WTB/Looking for 1/4" inch front top hat spacer Looking for a pair of 1/4" front top hat shock spacers for a 5th gen. Hoping to find locally in Long beach, Ca. Unless you are able to ship. Thanks in advance! PM me so I'm sure to see your reply.

PM'd Let me know if you didn't receive it.

Are they testing anything on the 2wd 5th gens? User manual states c clip 3/1 max to achieve 2.55in max lift but mine is set at 4/2 and only yielded ~2.25in.:hunter:

Just installed my 6112 today at the 4/2 setting. Pre install lowest point of fender to floor messured 33 1/2 inches. Post install and after driving 12 miles lowest point of fender to floor messured 35 1/2 inches. I didnt have enough time to grab washers to install the sway bar drop but runner is...