Recent content by b_w.

Hi, looking for a pair of front and rear bumper covers, preferably dark grey for my 2013 sr5. Located in Edmonton. Let me know if you have a set. Txt 780-993-2367. Edit...CDN SR5 bumper is the same as a US trail rear. Let me know if you have one. Tks.

bump

Asking $33,000 Canadian Picked up a new QX80 for my daily driver so the 4Runner needs to go. Here are the details. More pics are in the kijiji ad linked at the bottom. I am the original owner of this 4Runner and bought it in December 2012. It is the SR5 trim with cloth interior. It has been...

ended up getting an new rack from the dealer as well as rebuilding the power steering pump. finally started working on the rack this weekend and it is a major pain. taking everything apart was pretty easy and used the sawzall to cut the rack bolts off. I also have new bolts and will install...

looks great!

Thanks. Will take a read through.

I am wondering if it can be lifted enough by loosening the engine mount bolts and jacking under the oil pan with a piece of wood to spread out the load. Maybe loosen the tranny cross brace a bit too so it can sag slightly at the back.

I did. Thank you for the link. The rack is leaking badly where the inner tie rod attaches on the passenger side. Pump is also dripping. I had the wife turn full lock to lock while I watched from underneath. Over a few full turns the reservoir drops and there is substantial fluid pooling...

Warranty is 3 year and 60,000 km bumper to bumper + 100,000 km power train. I do not believe power steering is power train. I am just going to bite the bullet and order a new rack and pump rebuild kit. Wish there were some documented diy replacements of this. FSM calls for the engine to be...

Pics of the carnage.

Hi guys, I believe my steering rack has bit the dust on my 13 SR5. 3/4 way through my road trip it started spewing fluid out the passenger side inner tie rod. The pump is also dripping some but I have not confirmed if it is just a loose hose or a seal has blown. Based on my quick research it...

just get one of these and it will be easy.... :bigok: The 4Runner has the 3 inch Metal Tech long travel it with Icon 2.5's 285/70/17 Duratracs and the 80 has 4 inch kit with 37" MTR's.

get some scratches on it to get it over with!

with spacers you will prob need to chop the body mount some. Easy to do with an angle grinder.

Get a full set of skid plates while you are at it. Bud Built is top notch.