Recent content by BarrRunner

Did you ever figure out what the clunking was? Currently have the same setup and same noise coming from front.

For sale 5th gen 4Runner suspension lift. All parts have 30k miles on them and in good condition. 6112s are set at 4/6 and come with top caps. Bilstein 6112 - $550 Bilstein 5100 shocks (one has ripped boot)- SOLD Eibach 1inch rear springs - SOLD Local pickup Denver CO

Pm sent

4- 275/70 17 BFG Ko2 Load range E 15k miles Always rotated every 5k miles, even wear and plenty of tread. One tire does have a small plug but it’s always held air with no problems. Sold

Pisgah National Forest, NC

PM'd

Get the 6112 for up front and go ahead and buy the 650# springs. That way when you install the bumper/winch there will be minimal sag. I have the 6112 and they are an awesome compromise 2.5

Maybe a little bit of rake with that setup, if you can live with it I say go for it. You could instead do a 1/2" spacer in the rear

I did the 2" setting (6/4 for non-kdss), and used the Eibach 1" in the rear. Sits pretty level with 275 ko2.

Some jackhole backed into me. Let me know if anyone has a front valence laying around. Don't really want to buy one from the stealership. Located in Atlanta, GA

Wish it was Spruce Mica instead of army green

2” front 1” rear, stayed 275 to avoid possible cmc

Good riddance stock suspension

Yes, you need to flip those numbers. 2 inch front and 1 inch rear would get you close to level

Ridiculous, for 60k+ the truck should be spotless. I give ya Tree-fidy