Recent content by best4x4xfar

GrindING Ground down a small piece of metal that my new 265/70/17s were rubbing on at full turn in the front wheel wells behind the tire. In the clear now.

What synthetic oil did you use?? That is amazing!

From a few weeks ago in NM heading to Canyon De Chelly.

Well said sir. In my experience, I ventured into the red zone once upon a time in the desert running low on coolant. I had about 120k on the vehicle and am now at 162k. I had the A/C on and ambient temp was around 100° +. I watched as I hit the accelerator, the needle would move up and if I let...

Little better now lol. Stoptech rotors and pads with the 13WL calipers from an '03 Sequoia. They feel great so far.

Got some 13WL calipers and some rusty rotors and pads off of a 2003 Sequoia parts car for $100 total! Cleaned the calipers first then painted them. Installed everything smoothly, but the rotors are too far gone. I thought the rust could just be light surface rust and would not impact the braking...

Haha looks great man. Now that you mention VHB tape, I could imagine drilling one big hole and VHBing the rest. Alright, maybe one or two holes for some peace of mind haha.

167 Did anyone else recieve hardware that looks like rivits? There are 6 of them. It looks like they would be for the bracket for the A-Arm. If these are not used, is everyone mounting that bracket with self-tapping screws? Pumped to get this thing on. Thanks to the OP and everyone that has...

Installed some U-Bolts in the trim between the rear quarter windows and the ceiling to hang cargo nets for storage. Came out really nice and sturdy. Yeah!

I just replaced my ITR, boot, and OTRE on the passenger side about a week ago because I had a puncture in the boot allowing water and debris to enter the rack/ITR. My Inner Tie Rod was completely destroyed meaning there was no grease in the joint and it was completely covered in New Jersey rust...