Recent content by Big Daddy K

What is the need of the PRV on the manifold? I have been collecting parts for building a system, and I'm not seeing the need for a PRV there. The compressor already has one, not sure what I'm missing. Has anyone tried putting a pressure switch that would shut of at the desired inflation level? I...

Sounds like a more permanent solution, but I know me, I am bound to screw that up some where.

So I've always neglected the paint on my 4Runner and never been worried about pinstripes. She is starting to show some age partly from living outdoors in AZ and I have started to do some detail work. Some of the trim is looking faded or has water spots that I can't clean off. Has anyone tried...

I've tried that and they say it doesn't help them... but hey I'm not riding back there. During the week I often shut off the passenger side and can feel the difference on me, but I don't notice much difference opening or closing the rear vents.

Well to be fair the A/C is okay for the front seats but my kids complain all the time. I end up with it running full blast with the vents pointed more towards the back than at me.

Does anyone have pics from the side? I'm kind of interested but it looks like it sticks out and blocks A/C vents and controls some. In AZ blocking the A/C vent, even a little bit, is a no-go. The A/C is borderline adequate in the summer already.

Hmmm this has my gears turning. I'm thinking of maybe a 2" with the top inset flush so rails could be used for tie down points. My simple one has one advantage of being able to get my folding table out even when there is stuff in the back...well as long as its not too heavy. Time to do some...

I'd go for the roll of reflectix and cut to shape. Aluminum tape or duct tape if you have to join two pieces to make it big enough. Reflectix BP24010 Series Foil Insulation, 24 in. x 10 ft - Weatherproofing Window Insulation Kits - Amazon.com

Kind of sounds like FJ summit...

XD has been around quite awhile and has a pretty good following. Wathed a few you tube videos and they seem like they might be worth a shot.

A few years ago I installed Morimoto 2 Stroke 2.0 in the low beam and looked for quite a while to find something. I never found any that seemed like they would work for high beam/DRL combo. Still have the halogen high beams...

If you have KDSS it helps to take the mount off the rigid side. Then it only need about 1/2” to fit the coils and spacer in. Working with a friend, you shouldn’t need a jack. But working by yourself it helps. Sent from my iPhone using Tapatalk

Got everything installed. This is 574/302 up front and 329 springs in the rear. Still running shocks from another Australian mfr that shall go unnamed. Going to have to fly in some IMS rears under the Mrs radar. Everything is riding pretty tall right now but I’ll get measurements when it...

Yep, that's a pretty big contributor. When adjusting are you taking off spring tension or just muscle the rings up?

Is that exhaust turn out standard 4th Gen or did you have it made?