Recent content by Bigmd

I can tell you from experience as I just did this over the summer . My axle seals were bad and locking the rear brakes up with fluid. My housing was rusty but probably could have been reused. But because of my OCD I like putting new stuff back in. I located a housing near me for 200 bucks. I had...

I just added a 1st gen TRD supercharger with 2.2 pulley. I went with a devils own methanol injection kit and a Kenne Bell boost a pump. It runs good at about 9lbs of boost with no ping. While i realize a stand alone tuner will get more out of the combo, I also realize it’s not gonna be a vehicle...

What’s a good site to use so I can upload pics here. Would like to put truck up for sale but can’t use photo bucket. Thanks

Yes i know. I only realized it was leaking yesterday. I’d been thinking this whole time it was rear main so I was putting it off. It will be a priority now. My buddy told me to check the pcv but as I recall it was put in October of 2018. It will get replaced anyway.

Ok so My 2002 has a decent oil leak from valve cover on driver side and seepage from plug grommet. I actually thought it was rear main until i really got under there and looked. My truck has supercharger with meth injection on it for the last 2 months . It’s been running great aside from trans...

Ok , I have the first gen gray supercharger and need the 3 long mounting bolts . I went ahead and ordered them using the length of the 2nd gen unit bolt size. I’ve since learned they are not the same . Does anyone know the length for the first gen version? Thanks

Ok thanks , I got the bolt specs from the black supercharger manual and ordered 3 of them. I hope they are the correct size.

Ok guys was able to find online from the part numbers hilife gave. It brought me to a intake parts list and it had the part number . Thanks again . Tim I just watched your supercharger install vid and it made me go look for bracket on my truck .

Hilife that looks close but not sure. Tim I put in two requests online at Toyota salvage yards. I have a few near me but am under the weather today.

Ok searched high and low and I’m only able to find the part name but no part number . I’m looking for the “intake chamber stay” . It’s the part that bolts to the driver side of upper intake and lower goes to block I’m missing completely and need for my supercharger install. Or if someone has one...

Hello , I’m looking for the long bolts that mount the 1st gen gray supercharger to lower manifold. Or the complete install kit. Thanks

Install bolts Hey guys , I have a 1st gen gray supercharger that I bought used . I don’t have the long bolts that go through the top to mount it. URD is out of stock but it looks like I can source the bolts elsewhere online. My question is are the bolts for the gray supercharger the same length...

Ok not home right now but it’s a little sticker with a number and barcode . Also says Magnuson on it . It’s to the rear of supercharger.

Ok, I recently purchased a used 1st gen supercharger from eBay. The deal was too good to pass up. Same with new parts and the seller said it was rebuilt. It does have a Magnuson sticker on it with a barcode and number. Does anyone know if this is a decal they put on after rebuild? I emailed...

Ok been planning a supercharger build for the last year. I had OBX headers installed two years ago because my manifolds were leaking and figured while i was in there mine as well. I’ve piecing it all together and this is what i have . I scored a rebuilt 1st gen supercharger with all new parts...