Recent content by blue1

Does Toyota make a front crank seal that is thinner (so the seal doesn't ride in the old groove)? If so does anyone have a part # for it? I really don't want to use a Speedi sleeve

It was the Dual Cardan joint on my driveline. Got it rebuilt--works great now.

What is the best way to tighten the top nut since the shaft spins? I was thinking vice grips w/leather pad as high up as possible, but there myst be a better way.

Sorry if I missed it in your post, but which perch (from the lowest one) are you using? I have the exact same parts coming this week.

SO yes :-)

Will the Tundra struts work with 99 4runner springs, or will I need to have tundra springs with tundra struts? Thanks

Are these the part #s? OME 60028 Rear Shocks OME 891 Rear Coils OME 90004 Front Shocks OME 883 Front Coils Is it 2 or 3" lift?

This is what I am wondering

Sorry V-6 J Shifter

Sorry V-6 J Shifter

97 v6 4wd 5-speed. DC joint is shot. Looking to pull one off a parts vehicle. Parts #'s are different for Manual & auto trans. I can't imagine they would be that different-maybe minor length difference. Anyone know or have any experience swapping auto driveshaft into 5 speed?

update

Did you ever figure out what this was? I'm experiencing similar problems at acceleration , but not at coasting, but with rear driveline

Thx. Yes, it is 1997. My wifes is 2007

Bad running gear noise **UPDATE** 1997 4wd 5 speed. It sounds almost like an exhaust leak, but its not. Mostly at lower speeds & increases with acceleration, but at a certain speed the noise stops. When I push the clutch in it stops. Coasting--no noise, but when I release the clutch it...