Recent content by Bmxer06pa

I'm open to offers on these. I need them out of my Garage!

Can you post a pic of your setup? I was able to fit that exact mount with the 1gal tank in my '03 V6. all I had to do was cut my hood liner.

I got spacers for the front seat bolts. It helps angle the seat back a little and opened up some headroom for me. I'm 6'5" and its still a little tight but helped.

1" and 3" billet rear spring spacers $50 shipped I purchased these and decided not to use them. They look like nice quality, but the company went MIA when I tried to return them. They have never been installed, just taken out of the box and sat in my garage. $50 shipped StreetRays.com: [SR]...

someone correct me if I'm wrong here, but if you drain some of your coolant into a clear container and also some of your tranny fluid into a different container you should be able to let it sit for a few hours and see if it settles out in different levels (an oil and a water level). but your...

This will sound weird, but have you smelled the coolant?

Just a follow up since I finally was able to take it for a drive. It sounds really good (I was guilty of being the annoying guy revving his truck at the redlight lol). It is definitely much louder under acceleration, but when maintaining speed, it isn't very noticeable. But take into...

I literally just installed the Carven dump exhaust. It hasn't left my driveway but seems to sounds great. It isn't loud, just a slightly deeper tone than my old stock exhaust (when I rev it, like I said I haven't driven it yet) it is much more tucked up than the stock exhaust which is a huge...

maybe if you take the spindle off with the cv still attached you can attack it at a different angle with the spindle secured in a vice or something like that.

I have a 2003 V6. Good point, I should have added that to my original post. Thanks for the advice! I would say the diff breather may either be a common problem between the generations or I have bad luck, mine was clogged and spraying diff fluid all over the back of my truck lol. I did...

Does anybody have any experience with these things? 4th Gen 4Runner Lower Arm Pivots – JD Fabrication It seems like it will solve a lot of problems and also provide some underbody protection at what seems like a great price!

I have spindle gussets in the garage waiting for me to get a few minutes to burn them in lol! I actually have done everything else on that list aside from the Power steering cooler. Any information you can pass along to me on that?

Thanks! I did actually regear and it made a huge difference!

I've been wheeling for over a decade, but made the switch to Toyota from Land Rover about a year ago. I've been building my Runner similar to my Rover, but now feel like I'm ready to dive into the collective knowledge of the forums to learn Toyota specific mods I should make and spares I should...

I drilled a hole in the bottom of mine, It's ugly but effective!