Here is a photo of how I mounted my license to the front of my 2010 limited. Cut tag on band saw top and bottom, about a 1/4 inch and mounted with zip ties. I was asked to show photo but don't know how to attach to a pm? Hope this helps Anthony who asked for it.
To: Lennard David, I was number 10 on your list for the LED lights for my 2010 Toyota 4Runner Limited. I am very happy with them and sent a thank you email afterword. I want to know if you have the reverse back-up lights available and the cost to send to 77318? Thanks, Brad Gunn
Thanks! Is there any chance of loosing any of the oil from the Xreas? Any photo's on how to from anyone is greatly appreciated and I'll drink that extra beer for YOU!
Harper, do you know if this lift is an easy install for us with the Limited Xreas suspension? I just want to lift my front only by 1 inch or so to level out the body. I've read that due to the Xreas oil lines that this is more difficult?? Do you know the part number for this minor lift in...
Thanks so LED! These are GREAT! (I just worry about the rear hatch lights falling due to little area for the sticky tape?) Thanks again, my wife thinks it is almost too BRIGHT?
I cut my plate down on a band saw, (1/4 inch top and bottom aprox.) and attached it with zip ties after drilling four small holes in the tag corner's and mounted in the lower screen mesh area. Looks much better, never drilled out the front bumper holes and no problem with overheating. (29,K on...