Recent content by Bran808

Nah unfortunately I didn't. Was last run of the night...like 930 so told him just concentrate on the tuning. I'll probably try dyno again later. Plan on researching headers installation, porting my cylinder heads, and trans cooler installation.

I have auto. I honestly have no clue. Just from observing nothing really significant until she went into 2nd then cut out at about 5700/5800rpm...dunno what the mph were. Haha....yah there isn't a lot of shops on island with a dyno to begin with and most of the shops are picky about what cars...

UPDATE: Took it to the shop to take a look at it....I was out of ideas. Turns out I nipped one of the MAF wires when I cut the electrical tape around the rubber boot protecting the wire bundle in the engine bay. Now she runs perfectly. Even got it tuned....9.5PSI of boost and a little over 200HP.

Thanks ShakenBake! I had emailed Magnuson to ask them where it went. They sent me the same Figure G but told me "I think you will need to install a "T" fitting to connect the line to the evap line....." That didn't make sense to me but looking at the whole figure I did find the "T" that goes...

Btw truly appreciate your feedback and response!!

Fuel filter “out” is towards the engine. Checked the wiring and re-soldered the C plug E2 function wires. Still nothing. Read up and watched some vids on electrically checking the MAF ports and wiring. What I found was that it seems on the harness side my ground for the MAF sensor side isn’t...

Confirmed routing. Even blew into the hose with the AIC one way valve to make sure air was going in to the manifold. Gasket was from the SC kit and installed correctly. Yes, she ran perfectly before all the new stuff went on. No ECL, wasn't running roughly, started as she's supposed to with...

Help SC & URD 7th Injector Install Need advice/suggestions/help. Runner starts but dies after a few seconds. 1997 4Runner 2wd 3.4L 5VZ-FE ~92,000 miles Borla Exhaust Injen Intake This weekend this is what I got done: Replaced Starter Replaced Alternator Replaced Heater hoses with HPS...