Recent content by brkosk

Cool! Where did you get it?

Agreed. I tried to avoid using it when I did mine. Finally gave up and started cutting. Cut as high up on the shaft as you can.

Well.. Good news is I finally got everything wired and closed up. Bad news is that the wire didn't exist in the 1G1 connector either. I ended up just fishing 2 wires through the firewall grommet and connecting them to the switch. I then connected the other lead on the switch to a hot switched...

Me too. I've been spoiled by auto climate controls in my last few cars. I know the auto conversion would be too expensive so I'm not even going to bother. I think updating to the 3 knob setup would modernize the interior a little bit. If I could find a proper wiring diagram for the 1999...

Has anyone with manual climate control tried to update to the 2001-2002 style with 3 knobs? My 99 SR5 has 2 knobs and 2 levers. The 2001-2002 style has 3 knobs. It doesn't look like the connectors are the same. However, the old style lever unit doesn't appear to have any mechanical...

Cool. I'll check it out when I'm home from work tonight and let you know how it goes.

Pin 5 on IG1 - Am I looking at the correct IG1 here? Thanks again guys!

I finally installed my tweeters last night. Wow- really easy using the stock bracket and screws. Perfect fit! Have you guys seen the Pioneer DEH-80PRS? I've decided I need it! Really great specs marketed towards the audiophile crowd :music: Burr-Brown® 24-bit D/A Converters: Three...

Looking over the C13 connector quick this morning. I have a black/wite ground on pin 10, which I've confirmed is grounded by meter and bolt by fuse box. There is no wire going to pin location 11 which is supposed to be the black/red wire going to the relay - it's just empty. Would you happen...

:thumb: Thank you for taking the time to check your diagram. I'll check it out tomorrow evening and see if I can get this sorted out. If all else fails I'll run some wires through the firewall grommet and ditch the relay.

Our 99 SR5 came without factory fogs, but the wiring was there under the bumper. I've wired in some LED lights using the wiring under the bumper and have purchased the proper fog relay as well as the dash switch with the orange light. I opted to go with the dash switch because it was cheaper...

Yes, 6 LED. I still can't figure out how to wire them tapping into the stock headlight switch. I can manually switch them on and off at the relay under the hood but the instructions I found looked to be for models with DRL. I was missing a wire in the C13 connector in the steering column.

How did the tinting go? I've done it once before and it always looked DIY.

Installed some Cree LED lights! :D Not bad for $38 on amazon with prime shipping. Rated at 1600 lumens each. Hopefully they last a while. I'm thinking of adding some black silicone around the edges to seal it up better. I was so impressed by the output I had to order up a 20" bar for the...

Should work. I plan on doing the same once I get new coils installed. I've found "RRO toyota trim packers" that are 10mm in width. I saw a review where 2 were used to raise the drivers side about 3/4 of an inch.