Recent content by bugman-74

I put my voltmeter in the useless "pocket" beneath the cigarette lighter. I did have to shorten the mounting cup, and make a custom mounting bracket (lower profile), so that everything would fit. I prefer the voltmeter down there, because even dimmed it is bright. The rest of my guages are Here

Some more info and pics: Stock is on top/left, Yukon #YA T35350 center, and Nitro #AXT34060 on bottom/right. The Nitro axle shaft is plenty long enough to cut to exact OEM length. The overall shank is noticeably beefier. It does not have the 7th flange hole (oil slinger). The flange thickness...

Just ran across this thread - Here's was my solution: Oil pressure and water temp in the overhead console. Remove the "sunglasses/garage opener" tray and install a couple mounting cups. IIRC, I did not have to modify the mounting cup or the supplied mounting bracket. Fair warning: I'm not sure...

Made a few phonecalls, heres what Yukon says: For reference here are some part numbers: #YA T35350 is Yukons 1541H shaft, 29.25" long #YAW T8-30-29.0 is Yukons 4340 Chromoly shaft, 29.125" long #AXT34060 is Nitro's 4140 Chromoly shaft, 32.125" long (cut to length), made in USA. Im going to...

Hey Guys, For those that have picked up a set of yukon axle shafts in chromoly or 1541H (#YA T35350), did you notice that they are shorter than stock or am I just "lucky"? They are advertised to be 29 1/4", but mine measure around 29 1/8". Stock seems to be closer to 29 5/16" (on my '99 5-speed...

http://www.toyota-4runner.org/3rd-gen-t4rs/202406-tcase-trans-breather-extension.html

http://www.toyota-4runner.org/3rd-gen-t4rs/202406-tcase-trans-breather-extension.html

Sold Sold

Both rear tail lights with harnesses (no bulbs). Came off a 1999 4runner. $70 OBO shipped to the lower 48. IM me.

Front right parking light assembly. Good shape. $28 shipped to the lower 48. IM me.

SOLD! Hey Guys, I have a set of D Farms 3D printed flare caps. I went to 33" tires, and had to yank these for clearance. You can see them installed on my rig here. Every rig is different, so you may need to massage them a bit to get it perfect. Good condition (though, slightly dirty). $45...

Driver side Airbag and Clock Spring out of a 3rd gen 2002 4Runner. Local Pickup, IM me.

Could've sworn thats where I grabbed mine a while back... But you are right, no 1.25 pitch. Fastenal or holo-krome would be the next places to try

These are not quite the same, but they are good alternatives.

File this parts list away for future reference. (1) Flat head cap screw, M10 X 1.25 (pitch) X 70mm long (1) Hex head cap screw, M10 X 1.25 (pitch) X 135mm long The FHCS is no problem to find. The hex head bolt in 135mm length is a little more tricky. I suggest buying a 140mm and cutting it...