Recent content by busmup808

Wheel studs 2 week ago I jump in my truck to pickup my son from finishing school, I take exit 13A 78 Aiea/Honolulu towards Redhill and I feel a thump and the truck starts shaking slightly. The shaking starts getting worse and I put my hazards on and start to merge to the right side off the...

Drive shafts are done and installed I had to shorten the front and extend/balance the rear shaft.

More pictures More pictures of the wiring that had to be done

Wiring is done I completed my wiring yesterday and I started the truck up. I took some cranks, but it purred like a kitten when I let it idle. The truck was loud as ****, because I’m only running the TRD headers. I have to finish my exhaust and install my 2 driveshafts and it will be done to...

It starts Big Mahaloz to Team_Jake for the diagram and information needed to make this swap successful. You are much appreciated. It’s been a while since I stepped on a clutch to start a truck, let alone drive it. I think 2008 was the last time. I still have to finish my exhaust and install the...

Inside wiring almost done I only have one more wire to connect and that is the wht/red wire to the clutch release switch on the top of the clutch pedal assembly. I installed the blk, blk/wht, & blk/yel wires that I had from a factory wiring harness from when I purchased the truck. I will post...

Outside wiring done I wired the reverse lights and all 4HI, neutral, and 4 LO switches on the tcase

More pictures 5speed is in and now the wiring begins

Revised Mahaloz Team Jake and all who contributed

Mahaloz for the input, but this is just a temporary thing for me to move the truck around. I have a clutch/cancel switch with pigtail coming in next week and the clutch release sw/cruise release sw on the clutch assembly will be wired in correctly. I would never make this my final. I’m taking...

Ewd The colors and PIN numbers match the same for my 98. I crossed reference everything and it is identical

Team Jake Much Mahaloz . I figured it out after looking at my FSM & EWD. So if I understand you correctly, if I get a small piece of wire and crimp 2 spades on each end of pins 5&6, the truck will start? There’s a guy on YouTube that did the same conversation, but plugged the park/neutral...

I found it CLUTCH START SW=CLUTCH DEPRESS SWITCH CRUISE CONTROL CLUTCH SWITCH=CLUTCH RELEASE SWITCH Got the answers by looking at my FSM and it turned out the same, just worded differently. Much Mahaloz from Oahu,HI

R150F swap Well my trans blew up last month and I was saving my R150F manual transmission for a 01-04 Taco double cab build. I decided to swap the transmission in my runner. Swap was pretty straightforward. Note to self and whoever wants to tackle this swap. When installing the Manual trans you...

Help please PARK NEUTRAL SAFTY SWITCH= on automatic transmission CLUTCH DEPRESS SWITCH= on clutch pedal assembly? CLUTCH START CANCEL SWITCH= on L dash CLUTCH RELEASE SWITCH= don’t know where this is? REVERSE LIGHT SWITCH= on manual trans So basically I just want to confirm where the CLUTCH...